Can someone help me to find dpf off switch on friend's Skoda Roomster 1.4 tdi EDC17U1 or good solution? I tried to find, but no lucky. I bought swiftech dpf off solution for this car, everything is ok, but after 400km display show dpf problem and no dtc on diagnostic.
Good day!
I continue to play with adapter Nexiq.
I think, that Nexiq - the API-compatible, multipurpose communication device.
In the description it is told, that it Pass-Thry the device.
Once I have found out, that Nissan NERS can use it.
But while I did not try actual work.
But I anywhere have not found acknowledgement of work NEXIQ under J2534 protocol.
Only once, in INI files, I saw mention - ALDL Pass-Thru ...
Setting for Nexiq (as it is accepted recently) it is a combination of setting INI and DLL files.
From various tests to become clearly - that opportunities are closed by way in the software.
Probably - Pass-Thru is a prototype of management and a configuration of adapter Nexiq.
In archive - some files and screenshots of work with Nexiq.
Best regards,
Dmitry
Hello i search the manual for this product.
I never had the manual from seller.
The key device had 8 DIP Swithes and 3 LED (red on the front, green and yellowat side) but i don't know how to use it.
here I post pictures of PCB from Galletto that is supposed to be clone. It has troubles with K-line. Can someone confirm if it is really clone or some cheap China hardware with few modifications?
I saved form an bmw 325 tds the tuned eprom and put in into another /the same sw, hw ecu Bosch 0 281 001 380/, but when is started the car was high the rpm. Anybody can tell me what is wrong? It was 2 eproms, and i was copied just the tuned eprom.
Thanks for help!
Chrysler Voyager 2.8 CRD Automatic (EDC15C7, 29F400) does not accept any map modification, even if only one parameter changed
When I upload any tuned map with FGTECH Galletto 2 the car wont start (the MIL is on, the dasboard beeps one and the fuel pump and most of the instruments are not working etc)
The checksum of the modified file should be correct (checked with ECM Titanium).
If I write back the original maps the car starts without any issue again.
Hello guys,
Few months ago I bought a first my carprog ver 4.1. After short work with it I found that this unit don't work properly (most of functions don't work at all). The moment that I lost my nervous was when the counter has started to count down. I tried to read and reprogram AT91SAM7.. with one of solutions in the forum but without success. The scheme of h-jtag wiggler programer is on the attachment file. Please give me an advise where is the problem?
