Hi , Members
For BMW with 20-pin conector (with exceptions) you need ADS Interface which is different from standart OBD interface and the interface work only with serial port RS232 or with PCMCIA card (with modifying ) becouse use different signals between car and PC and can not work with USB or USB to Serial
Here is simple Interface for DIY
I test it , work 100%
Work with INPA , DIS
how does startkey center works ??
somehow I managed to load the xentry key but I can't do it with the das key
I copied the starkey on a usb stick but no avail.
I am installing , or try to , xentry 11/2012 1/2dvd and 01-02/2013 2/2dvd as a 01/2013 xentry installation.
I am a old dude so I hope you are a bit patient with me.THANKS!!
I just acquired the muxer and laptop. Still have not been able to connect. My first issue was I could not select Ok on the connections menu, I replaced the sdconnect toolkit as suggested on this forum and that fixed that, I found that my green cable was bad causing it to never connect with the cable plugged in ie: red x on ethernet on bottom right, replaced the ethernet cable and now it connects, shows a yellow unlocked padlock 21 on the bottom and says accessible, when I go to configure the wlan per the instructions I have I get a error 749 (Due to network problems, no connection to the SDconnect can be established (749) No SDconnect is selected or the desired SD connect cannot be selected. The IP addresses for the lan and wlan are set according to instructions: lan as 172.29.127.119/255.255.0.0 and wlan as 192.168.2.221/255.255.255.0
Can anyone help me? I've been at this for a couple days and ready to pull my hair out! Thanks
as above genuine vcm they are second hand I have 3 from bankrupt local garage in full working order £700 each plus postage.pics can be sent if requested.
cheers
paul
I need your help.
I can't save fille .xml so i can give for activation.
When i Click Save nothing show up in folder.
Also nothing happening in USB when I inject it.
I have instaled already delphi 2012.3, but doubt that is the problem.
Does anybody know what should I do.
Hi all got nissan qashqai 2013 deos any one no how to programme new intelligent keys to car i have got nissan cosult 3 have programmed keys so car starts wen key is in the ignition but dont no how to programme the intelligent side of it thx
someone can help me on how I do to clone a BSI of a Peugeot 307? what steps should I do and what equipment do I need? is the first time I do this and needed some help.
I have a client who have a Mercedes W202 C 180 wich model Year is 1997
he was driving the car when suddenly it starts trembling and Shivering .
Anyway after Star diagnosis Complete I got a Cylinder 4 problem.
I replaced the Coil 1-4 , it was good till suddenly when testing and driving the car it did the same problem and after tests and swapping the Coils the Star Diagnosis system keep giving me fault on Cylinder 4...
Again i replaced the same coil 1-4 with another new one it gave me a good result and same problem again also came back after driving the car.
I think personally it is an ECU problem with Coils Output but i need some help to fix the ECU and repair it because i have no experience in Doing such as this stuff
Hi m8t´s, im need some help finding some maps on this ECU found some maps, but misses me the factors, need help here, its a citroen saxo VTS 1.6 16v 120hp
Hello
I have audi A8 2011y. And cannot correct odo.
Did it with original AVDI, but without success. AVDI cand do only 2010y
Have anybody solution?
Dashboard eeprom enclosed. Original km - 37260, need 25300km