Hi guys, I have a big problem with this radio from A3.
I can not read code so i read bga from other radio and write to this one, after that radio dont start, any ideas? BGA soldered good, all things connected. I've done another A3 and it work.
Heya all
I have a 2003 SLK230 that will intermittently not crank the starter.
BAS fault code - C1025 CAN Bus - CAN message ECM is faulty
ESP fault code - C1022-002 + 004 CAN Bus fault. CAN comm with Eng system is faulty
C1031 Eng control module not identified or incorrect module
No faults in Eng ECU.
Can also cause Rad fan to go full speed when no start. Almost like ECM is open circuit???
I'm hoping someone might be kind enough to take a look at these and help me figure out why I can't get rid of this speed limiter. This is set at 80mph for USA.
I sell my FG Tech v54 Eu Clone
Work great with tricores and bdm and obd
I have buy from deutschland
Good qualtiy
Installation cd and you can use it
Price are 650 euro
With al cables and tricore resistors
And bdm cable
More info send pm
For sale: MPPS v16 EU made (16.1.0.2) + software on CD.
Works without loader etc. on Win XP and Win 7 32/64bit
PM me for link to pictures
Price 200USD + shipping (paypal)
Shipping from EU.
edit: forgot to mention it comes with 81 pin adapter
Thank you for your help beforehand.
I have a Mini Cooper S which is being exported to a country which follows the metric standard.
I am wondering if it is possible to change the ODO from Miles to Kilometers in ISTA/P.
Additionally, is it possible to code the daytime driving lights to automatically turn on when the vehicle is started.
I appreciate all input.
10/27/2014 Update,
We attempted to covert the vehicle through ISTA/P to "Canadian Version,'" And all works well until the Kombi decides to switch back to "Miles" instead of Kilometers. After more digging in ISTA 3.0, I am getting a code that the KOMBI and GM have different VIN numbers. After attempt to read out the information in the GM, ISTA doesn't display any numbers regarding the VIN number, Software ID, and Programmable state of the module. The only data that I see when I query the GM is Hardware #.
Any ideas as to what will cause a situation like this? (defective GM?)
So we are going with the Gm (Body Controller). Is there any way to write the current vehicle vin in a used module, or do we have to go to the dealer to get one?
Make active ECU diagnostic and programming. Do engine tests, see wiring diagrams and many more. Calculate alphanumeric codes with our Iveco AlphaNumeric Code Calculator software. Supported brands and languages.
Looking for ESItronic 2007/1 for an old KTS500 device, this is the last version that has support for KTS500.
Have the ESItronic KTS500 Final Version DVD, but it needs a preinstalled KTS500.
I have a question if any body came across or how too fix it?
I have a DAS Xentry 03.2013 on Hard Drive and on VMWare
Since the day i got it, it was always on high cpu usage check attached picture
I tried other version and they are never high on cpu usage
What caused too be this way and what can be done too fix it?
other then start using newer version
Thanks
