Please help!!
i need ori. File from 93 Alpina B3 Bosch ...413 ECU 64KB
Thanks

Hello. Tell me please, what equipment is best to work with FORD Visteon. Available only Galletti v.52

Need help to remove dpf Iveco daily 2.3 edc16c39....pleeease.... Original flash here
Ecusafe don't work.
Best regards and thanks

Hi

Could somone adjust milage for me?

A ducato, 2013, merelli dash with a ST95160 needs to show around 10,000 miles

thanks

pleas i need code for philips sc201d
s/n: gm1201n9428341

Hello
Need please egr off on bosch med 9.5.10 VW Touran 1,6 FSI?
Please help Thanks

Regards
Please help ?

Regards

Attached Files

03C997056F.Bin.Bin.rar

82

584.2 KB

Download

This is the final DVD Release ' R2.0, V 09/2014, (2014-09-03)' DVD 1/2 .

As of DVD 01/2014 we always need 2 DVD’s

This is 09-10-11/2014 DVD 1/2

After finishing installation of DVD 1 / 2
you have to start manually the installation of DVD 2/2

This DVD contains 0 additional DVD AddOn
--------------------------------------------------------------------------------------------
This is the final DVD Release ' R2.0, V 09/2014, (2014-09-03)' DVD 2/2.

This is DVD 09-10-11/2014 DVD 2/2 based on installed DVD 09-10-11/2014 DVD 1/2.

After finishing installation of DVD 09-10-11/2014 DVD 1/2
you have to start manually the installation of this DVD 2/2.

This DVD contains 0 additional DVD AddOns


------------------------------------------------------------------------------------------------
I got my 09/2014 discs yesterday and they have the AppID 252/253 block on the setup.inx's as expected..

I can't get my sid.exe to work at all anymore so if someone wants to perform the magic on them and repost them, here they are...

09_2014 Setup.inx.rar

175

1.3 MB

Download

Looking to see if there is an update for 2009 Saab 9-3 (with OnStar) bluetooth software, it has never worked properly and will never re-pair with a phone after a power-off.

hi can anyone help

i need code for

Grundig 1m0035186k

9,18443-8185 G.H0 08-00

Aura cd 2
So30/H

SEZ2Z6E3082748

if possible

thanks you

help me tuned + EGR Off please
VW Touran 2.0 TDI 136HP

Thank you for any replies.

Can someone help me with a "Walk thru" of how to update the software of the rear SAM with Xentry?

Mercedes SLK250 2012

Pleas help me , i need immo off on this dump.

W221 Japan Command Radio Frequenz. How we can make it Europe Frequenz? software or Hardware?

Hi Guys I have a ford focus 2013 BM5T 14B321 CF need crash data clearing please

Attached Files

BM5T 14B321 CF FOCUS CRASH.rar

68

1.43 KB

Download

I need someone to reprogram ecm komatsu controller transmison

Komatsu
Model: D65PX-15E0

who have Toyota TechStream V9 keygen.

i have get this errors ,i have replaced the lambda nox sensor and i still get this errors ,i heard that is a box with the nox sensor where is the box..???....i have checked the wiring and its ok... what shoult i do ,its a golf 5 ,1.4 tsi...

Hello everyone,i have mercedes benz W220 v6 112 engine,the car was having misfire then i decided to change ecu then the misfire goes,Then after few time the misfire started again like it was before.
can someone help me if there is anyway of repair this ecu instead of changing the whole control unit since it cost me.
Also someone help me the major cause of the problem..
Thanks
Attached is the picture of ECU

Attached Files

w220 ecu.rar

25

544.29 KB

Download

Hello,

I'm quite new on the forum and I'm interested in remapping the ECU on my car. Here are the car specifications:

Audi A4 B7 8ED avant quattro 2.0TDI - 170hp BRD engine - 2006.

Ecu information:
Siemens
Hardware Number: 03G906018AQ
Software Number: 03G906018AQ
System Type Number: R4 2.0l PPD1.3 G

I have attached the original ECU dump to this post.

My request:
EGR off
DPF off
and the ~200hp map which also reduces fuel consumption by a bit and if possible lower smoke output


Could you please provide me with 2 maps; one with the DPF on and one with DPF off. I haven't physically removed the DPF yet.

Thank you for your time!

Attached Files

03G906018AQ.zip

148

55.74 KB

Download

I have one Land Rover FReelander 2.0 diesel engine spins but not starting.
On ecu i have fault code 1DF5 ews timeout.
Ecu is DDE 7 788 053. Bosch 0281010300.
Immobox EWS3
Can someoane help me to syncro DDE - EWS?

Attached Files

Freelander EWS+ECU.rar

85

730 bytes

Download

Hi everyone,
I have a problem with a 2008 panda 1.3 diesel multijet,
the starter is turning, but the engine does not start. As I turn the ignition on, the pump works, all lamps go off, glow plugs are ok, glow relay works, battery ok. It only starts when I spray some fuel directly into the intake. After it starts it works fine. I checked ground points, tightened screws, checked crankshaft and camshaft sensors for dirt. when I turn engine off and try again, it cranks but no start. it only starts with help of spray.
I suspect that it doesnot get enough fuel in moment of starting, but do not know why.
There is also one funny thing, as soon as I switch the key on, and pump starts running, the injectors are heard clicking. Should they not work only as the engine cranks?
please help

Hi all
I've test change ECU for W221.
- Initial starup -> offline -> first line " can read old module...blabla" -> get coding from old ECU -> replace virgin ECU ->programming...

But my laptop error, i'll try again tomorow.
Anyone pls let me know, do i miss anything ?
Can i write vigined eeprom of old ECU to other new ECU ? I've tried that. Das can read, program,learn new ECU but can not read value then stop
I thing we can get SCN coding from old ECU.
I am right ?

Hello!

Can anybody help me with EGR off solution for Visteon DCU102? Ducato 2.2 Multijet 100HP 2009.
Thanks

Attached Files

Ducato Visteon.zip

52

221.09 KB

Download

Hello
Need please EGR OFF on siemens SID803A Peugeot 2.0hdi?
Please help Thanks

Regards

Attached Files

sid803a peugeot hdi.rar

73

39.36 KB

Download

Hello,

Can I update EPC and WIS from 3.2013 directly to 3.2014 or is it nescessary to do all updates from 3.2013 till 3.2014?

Greetz,

Please if somebody give me tuned file for my Toureg 3.0tdi
. ori file in attach.

Hi to all,I need help to immo off on med9.1 bosch number 0261s02111

Attached Files

original_EEprom.rar

99

757 bytes

Download

original_Flash.rar

122

688.21 KB

Download

Hello I was reading the eprom 93C66A 8 bit file off a denso Suzuki 2010 Gsxr1000 when I accidentally cleared the whole chip buy writing all FF,s. Can anyone help with a file so I can rewrite this EPROM please, desperate.

1.6 16V HDI 0281011633 1037372282 5.349407
I'm looking for the original file on the BDM
for any help in advance thanks

Good evening friends of the Forum.

Shortly did buying a multi diag ACTIA seller dissendo be version 2014 Plus the installation cd came written 2013.2.

I did the installation and to my surprise, there is less models that produced no my old scanner AUTOCOM. mainly in Part toyota.

Another issue is the VW Amarok does not have ....

Another issue related to and support the truck because it has ????

My old-AUTOCOM CDP-PRO, had more cars supported the Multi diag ....

My question is, is there activation for multi diag 2014? behaves more models of cars? what is the value?

Hugs to all

Thank you