BMW
M3
1037500774
0281015130

I have this lovely car and have start to work on a project for a better fuel economy.

Need the original file or a similar, any one can help me.

Good morning M8's

What is, or is there a/the correct procedure to permanently block the install of the new EWA NET admin tool after you have gone back and installed the Classic Admin tool.

It seems that every time I want to update either EPC or WIS I start off with the classic tool, however after install of either EPC or WIS the new admin tool over writes the classic and I have difficulty getting back to the classic tool to install.

Advice will be appreciated. Thank you

Why doesn't anyone use the thanks button? It is a common courtesy when someone tries to give you help.

hi friends

i'm looking for way to run DAS on W212 for exemple, but i want run DAS without XENTRY

i'm thinking install both and after remove xentry or maybe just install das but how ?

thank you for your help

srs 2L1A-14B321-DI, epr 95160, The problem - always on error 19 but the circuits are tested and in good condition. I need a dump eprom 95160. thanks......

if you download this , plz dont forget donations MHHAuto for keeping

dowlnoad: click Here

Hello Friends
Someone who can provide the SOFTWARE VOLVO IMPACT 2012, Thanks and regards

hi friends, i have a renault clio 1.5dci of 2001, the eeprom of bsi its damage,its possible get pin from vin?

VIN:VF1SB07CF27928809

regards

hi
im looking for any diagnostic software/workshop manuals for the tata Indica or as its known in the uk the rover city rover.

delete

Hi,

Can someone share how to open an ECU with glue present as seal ? With what tool must I heat it up or is there an easier way to do it?

Hi all,
turns out it was just a loose plug, someone had been messing with
abs light.


Hi,
Can anyone help me with some info on 1999 Jag XJ8 Dash ?

On first inspection.

the dash on the car is dead, only indicators and main beam illuminated.

Are there any common failures ? does the dash hold the mileage ?

I dont have any eeprom readers , is it possible to move milage chip to a scondhand dash ?

I have some info, wiring etc and will be taking a closer look at it tomorrow.

Thanks.

HI
HOW CAN I DO OFF FOR THIS ECU
citroen xara
Siemens SID 801A
5WS40106G-T

SW 9653647880
HW 9647423380

93C56 OR 29F400BB ?
thank you
elmassioui is online now Add to elmassioui's Reputation Report Post Edit/Delete Message

I have a question, when I first activate the program I was geting SI information for repair operations, but now I dont get it no more, only on some cars I get wireing diagrams, did I do something wrong?
it is version v32b

Thanks

Hi there need help with this problem i bought sd connect with hard drive allready loaded for dell 630 . It will connect wirleless and wired working on DAS , but if i try to go through xentry it comes up no access authorization code, software version11.0.8 data version dvd5/2012 .Is there a fix for this problem with a different keygen? [/size]

Anyone know how to find Saab global tis & saab tis 2000 ?

The links in this forum doesent work

Thanks in advance

Hello

Im looking for a VCM that can reset DPF after change, and also do selftest/regen mode for DPF.

ive been told that quality varies alot on these....

any recommendations?

hello all members there, would somone share the link to download Vas pc v19fr .
thx for reply in advance

Hi all new here,

Does anyone have the latest Nav software for RN-S2 USA

Thanks

Hi,
I see there is a version 16 mpps available in Europe anyone have any info on this ? Or anyone got one ? Try to get info from seller about car list but no joy. Interested in differences between V12 , more cars etc. Interested in your views or personal experience.

Thanks.

Hi Guys,

Just want to share my experience with recent DAS/Xentry versions.

I have W204 and W212 in my garage, in order to work with them at once, I need both DAS/Xentry working.

I was using 01.2011, it works well in most of W204. but due to some reason, I was pursuing the upgrade of my DAS / Xentry

(thanks for all the help from this forum, and of course web master!)

Here I would like to share some of my experience (with 100+ hours fighting with them )


2011.01 - Golden version, has no too strict check and protection.
suggest for beginner and people who has car manufactured by then
(no need to chase latest version, seriously!)

2011.07.- Golden version + , but getting difficult to install them because it requires many manual interruption during the installation, replace commonlic.dll for few times. install it only when you needed.

2012.01 (Suggest skip) - has some strange issues - even with all the add-ons applied. when use Xentry for some certain car of model, it freeze in "record boundary data" forever in Xentry.


2012.03 (Best so far) - working well in both Xentry / DAS even with base version installed. no strange bug, installation fixed works, DAS standalone works, and DAS special function no password / prototype works.
highly recommend for people who need access both Xentry and DAS cars. but installation is not as easy as 2011.01

2012.07 (Newest version, but not stable)

- I tried to apply all Add-ons but it still has strange issue when diagnose
certain cars in Xentry - it prompts error and shutoff in 20 seconds,
DAS works - but he Xentry parts made me worry about the stability. that is most difficult version for installation so far. 2 DVDs for two separated installation, new protections, (star key center) and solution is not complete yet.


That is all about my personal experience, I hope it can save some of your time when choosing the version. pursue the latest might not be a good
strategy because if it's unstable, it could made thing worse.

Please i have GENUINE SPX VI ALLIANCE INTERFACE for nissan and renault hardware and will like someone to share the Software with me that can control this hardware... thank you...

Would someone share the ECU plugin for NYO4 ?

Hello to all MHHAUTO.COM Members,

I am searching for STW 2010c , can someone share a link or torrent?

Thanks in advance.

Hi,
I've got a Digiprog clone and was wondering if anyone has the hook-up diagrams (mainly interested in the PSA stuff). Any help is appreciated.

Thanks

Hi!

I'm trying to update my Icom firmware but I can only update the System/Boot firmware. Everytime I try to update the Application firmware, I get a server timeout, no matter which browser I use. Do you have any idea why this happens?

Thanks a lot in advance!

Hello,
Here is mazda v80 my brothers!!!!!

Attached Files

mazda 80.txt

504

59 bytes

Download

Hi.

I have some problems with this software. I have installed it and I can load it perfectly but pictures are not shown, anyone knows why?

I am using 02.2012 version. Thanks.

Hi ppl, does any1 have Wiring Diagram of this car radio?
It is Mercedes Becker Alpine (MF2297).

BR