Hi all, I want Liana Landirenzo Omegas plus software and circuit diagram and pin outs of the interface which is used to adjust the CNG to the required standards.
Thanks
I hope I have posted this in the correct section of the forum.
I have a laptop with Xentry/DAS 11/2012 installed. It can connect to older models through HTTWin, but I cannot connect to newer models such as a 211. I get two different errors each time and have supplied screen shots of both. (I have checked to ensure that HTTWin was not running during the newer model's connection as well.) Hopefully these errors look familiar and a fix is readily available. Thanks so much for all your help MHH!
Hi all ,
My friend is having troubles with his hyundai getz 2006, its loosing like every 1-2 months, for 2 years in a row, kind of bored to go every time to match them...
So i anyone could help me to make this car to be "gremlin free", i mean immo off it would be very nice
Attaching the dump
Thanks all in advance.
hello !!!
I need help. Xsara Picaso 2001 dash problem. I have a file with 145915 km, I need a change to 161550 kilometers, the EPROM is 93C66 , BSI is empty. BSI Valeo with NEC procesorom.dash is VDO. My every attempt to change , ends with 999999 km .
thanks !!
I have autocom 2012.2 running. I'm wondering if it supports USA trucks?
Specifically 2008 Ford F150? I paired it with my truck using a bluetooth obd2 connector. No US Trucks in there? Can they be added and if so, one more question. I know this is a diagnostic software, but can it change the mileage also? I saw that it can get to the instrument panel on some vehicles and wondered?
Thanks in advance for all your hard work.
I would like to use Autocom or Carprog for diagnostics.
But if neither one can change the odometer for my new cluster, then what should I use? I know carprog can. and I saw a you tube video with a F150 in it? How come mine doesn't have it?
Hi All, I've installed the latest version of Peugeot Planet on my MacBook via BootCamp with WindowsXP (not virtualised). It installed with no problems and runs fine apart from when I try to read the faults on the ABS ecu it says "PP2000 unknown reference, ECU being referenced'.
Anyone got any ideas why this could be?
Is there a better software to use?
Hello,I want to change a BCM2 unit in an Audi A4 2010.It has a strange Processor 2 fault and the car is not starting.What tool can I use to program it?As the unit is fault I think taking the NEC the Watchdog and the EEPROM and soldering on the used unit is no good.And how about a new unit?Can it be adapted with PIN and VAG COM?I might be able to find PIN in EDC17 ECU.
thanks for answer
Here you will find everything you need for Vw Golf V- Golf Plus - Cady - Jetta (2004-2008) service manuall (BODY ELECTRICAL - TECHNICAL MANUAL - ENGINE ...etc.) ..
For all members with blocked or broken SDconnect original or clone devices.
I offer unblock service solution for locked /blocked SD Connect multiplexers.
If you have infamuous exclamatory sign on the SD Connect display your multiplexer unit is in inoperable state and needs to be unblocked/restored.
If you have chinese clones with 1014xx or 109xxx serial number which are already blocked in newer relases of Xentry diagnostic, then you'll need to change your serial number to safe one.
If your clone does not pick up all systems (especially IMMO, EZS, ABS) on short test on w310, w211, w203, sprinter,... models, then it must be revised and repaired.
Special service price to all MHH members. Details by PM please!