The left turn signal on the S212 I bought was broken.
I thought it was the headlight computer so I replaced it, but it doesn't work.
Please tell me how to operate it on Vediamo.
Or please help me.

I will buy a virgin file for the airbag controller 95910-D7230 TLH AB8 . Can be eeprom and flash d735 coding.

hola, necesito quitar el immo

Attached Files

bmw_bosch_edc16c1_bench_fullbackup_20241115114239.zip

4

688.34 KB

Download

Hi i need correction mileage 
6395450908
ori 204538
need 265978
thanks

Attached Files

6395450908 0L01Y EEprom.rar

3

792 bytes

Download

Hello. There is a Regal Raptor Model ATV, it has MT05.2 ecu. Can anyone cancel the speed limit?
ECU: MT05.2
Sw: SCT_0909

Attached Files

REGAL_RAPTOR_ATV_2023_650_EFI_40_hp_Delphi_MT05.2_OBD_NR.rar

2

74.69 KB

Download

I removed dpf, egr, adblue, i want more power at low rpm, and better performance in general if is possible

Attached Files

318d edc17c50 f30.zip

10

1.7 MB

Download

Please can some1 share this above file because I need make decat I'm removing cat remove P042000 Please will really appreciate your help

Engine: 1.81 R4 TFSI

HW Ver: 8k0906264



Sent from my SM-A235F using Tapatalk

Hi.
who can help remove DTC from this ecu?
P2004 + can be all intake manifold runner dtcs off if possible.

Thx!

Can someone please help me find the SOI, SOI correction by temp and Torque Limiter maps?

I suspect that the SOI card is located at 3AB74 12x16. But I'm not sure. 

Torq lim and SOI corr by temp i dont now.

Volvo V40 1.9TDI 102HP 0281001906 1037358369.rar

3

60.19 KB

Download

Hi i need SCN and EHS for WDD2040012R188214 please. C200 CDI. Old tcm not readable

Thanks in advance

HELLO I NEED IMMO OFF ECU ME ME7.8.8 PLEASE

I NEED IT URGENTLY, THANK YOU

Attached Files

MG ME7.8.8 ORI .rar

9

280.37 KB

Download

Looking for mercedes vito w447 instrument panel wake up can message. Please share, I need to power up cluster.

Hi guys,

can someone delete DTC in ECU EMS2 Mini Cooper 1.6 16v 2004 Year?

DTC: 

P0340
P0131
P1109

Thanks!

Attached Files

ori_p2580.rar

7

22.71 KB

Download

Hello to the community, I'm new here and have read a lot, but unfortunately I can't get any further.
I bought a used GID display. This display has not been unmarried. I then read out the 25080 eeprom. There I saw the code 0565. Then it was installed and I deactivated the theft protection. Then I deactivated the anti-theft protection on the CD30MP3 and entered the code from my Carpass. I then reactivated the anti-theft protection. Nevertheless, Display Safe is in GID and the error code shows me that there is no CanBus communication.
I have tried several times and have read that there is a counter for the security pass. Is that correct? Can this be reset?

Thanks for the help

Hello. I wanted to ask about a better tool to read mev17.4.2. Im using a kess now, but wanted to know, which tools You use. I would like to read/write without opening the ecu if its possible ? Thank You.

Hello, i bought a Nissan Primastar aka Traffic i want remap to some more power bcuz this car sucks 80km ;/ i don't know how to edit this map for stage 1 can someone make it for me? 

HW 0281010633
SW 1037363190
(used kess v2)

Attached Files

mapPrimstar80km.rar

2

143.85 KB

Download

Hello, can anyone help with the code for the VW Passat B6 radio
VWZ2Z2E3079218

Hello to all. Iam searching ways how to clone Cadillac cts me9.6 hybrid ecu. Anyone has solution? 
Thanks

hi, can anyone here disable the rear lambda and dtc's? Or could someone give me some advice? thank you very much!

Attached Files

PP95349_MSV70_0049PP0L732S_tune.rar

9

64.66 KB

Download

PP95349_MSV70_0049PP0L732S_fullread.rar

6

650.96 KB

Download

Hi, I have a W906 printer with 95 HP. I did stage 1 with ECM and Stagex software. It runs great with 180 HP and 430 nm, but after 8 minutes it goes into limp mode. Then it does not go more than 280 nm. I have also used the Toque monitor several times. turned off but doesn't help can anyone help me.

Attached Files

Mercedes_Sprinter_2006_(W906)_210_310_510_CDI_(2.1)_95_hp_Delphi_CRD3.20_ vj-830-p_NR.rar

5

1.49 MB

Download

12_11_2024_ 14_46_11 - stage2.rar

4

1.49 MB

Download

I need help with Ford KA MM9GF immo off. File read with KESS.

Attached Files

read.zip

2

577.45 KB

Download

guys anyone help with dpf egr off a 3.0tdi audi q7 already tried a solution but car drives in limp with stock file its fine

i can t do long coding airbac Audi a4 b9. i changed the airbag unit and i am unable to enter the long coding data manual.

haw can i do

Hi friends!

I have chk problems reading a MS45.0 with KessV3 slave. Now I need a complete Backup to restore the ecu.

Ecu: Siemens MS45.0

5WK93012 7530260

Photo attached.

Thanks!

Attached Files

Thumbnail(s)
   

Hello,


Searching who have a Ford seed calculator/generator. Interested in 3-bytes and 16-bytes generators. I have key pairs for testing. Thank you!

hello all i need dpf scr egr off 
for opel grandland X 2021

Hi all
I have immobiliser problem and
I need your help to turn off immo for ecu MED9.7.10 VW PASSAT

Thanks

Attached Files

95080 ORG.rar

12

472 bytes

Download

I have a vw Tuareg 2.5 tdi 2009 year with various electrical problems. Blinkers do not work, climatronic turns on and off every few seconds, windows do not work for a few moments and then come back, same with wipers, horn, central locking
vcds shows that there is no communication on can comfort bus intermittently
I started unplugging modules one by one starting with steering column electronics, climatronic, ccm module. no results
then checked wiring loom in the floor near both front doors to see if there is water damage but all seems ok.
measuring comfort bus can wires on one module voltage and frequency varies greatly every now and then, even with ignition off

Hello, can someone help me change the mileage in a VW Polo. now it is 253997 and I want it to be 264786. Dashboard TRW
thanks for help.

Attached Files

microtchip 24lc04.rar

3

581 bytes

Download