Does anyone had problem with peugeot 508 1.6 hdi with ELV. It has no ignition, its keyless key. Keys are okey... In bsi error have that no comunication with elv and no answer elv on request....
Does someone put emulator estade elv or change elv and what is procedure to put second hand elv?
Hello,
I have 2021 Ford Explorer after front crash and both sensors where missing so I bought new ones and pigtails for them but wire colors on pigtails are same. does SRS front crash sensors have polarity or no matter how to connect? Thank you in advance
get pml valve problems on my w164 ml63 amg 2007, by mistake bought new one from facelift 2009, on some site get info that they are crosses.
After installation getting ESP triangle light on dashboard without any errors in ECU.
Checked by WIS seems wire is same, maybe somebody knows where the problem?
Hello Mates,
i need someone who can install the actual ODIS Version, Etka, Elsa and ODIS E on Notebook. I would pay about paypal.
Is there any Mate who would do this?
For disabling the NOx Sensor or the ADBlue system in a car, is it enough to disable the according DTCs of the components and disconnect the Devices from the car?
Or is there anything extra that needs to be done for it to be a successfull off solution.
Currently trying to get a grasp on how the procedure actually works but the info i found is ambiguous at best.
Are there any resources i can dive into and learn from?
Huge Thanks in advance for anyone taking time to reply!
Can anyone help me clone this BCM module .
I attached the 95640 eeprom from both modules original and new one.
Both are the same code 1384105080 BCM250I.05 , same SW 3.08
Hi,
I am attempting to use a second hand ESL module in another touareg.
I have kessy, cluster, ecu for both cars.
I have the ecu on a bench harness alone, VVDI goes to read eeprom and extracts CS / pin no issue. It then fails and says "can not get module challenge."
Autel tools fail at the same step too. ECU is not immo off.
Please help me find the solution and ill buy you a case of whatever you drink.
I did a recent cloning job on a W246, where I encountered some unexpected issues.
Cloning Process: I cloned the ECU from the original using boot mode and completed the clone setup via bench mode with a KESS/KTAG 2 clone tool. The process was smooth, with no errors reported.
VIN Update: After the cloning, I observed that the VIN on the donor ECU did not match. Using Vediamo, I successfully updated the VIN to align with the W246's VIN.
Diagnostics: When I read the ECU for errors following the VIN update, the only active errors indicated missing components, which I attributed to testing in bench mode. Variant coding was verified and found to be matching.
Current Issue: The customer reported that after connecting the donor ECU, the car would not start. They do not have diagnostic tools to troubleshoot further.
I plan to visit the customer this weekend to investigate further. However, I would appreciate any insights on potential causes for the non-start issue, as the cloning process, VIN update, and initial diagnostics were all without apparent faults.
