Hi,
I have a problem with Audi A5 B8 from 2016. Car came to me with problem with steering angle sensor, it was not able to learn end stops. In meantime, when I waiting for new steering angle sensor, I got a new problem with steering lock with error "2811 - Electronic steering column lock control module - defective". I ordered a new module (8K0905852E), replace it, did immo adopt and it was working fine for 1 week. Now, when i finally received steering angle sensor and I try to install it, same error again, no ignition, just message that Steering is defective, no ignition at all and ODIS gives the same error "2811 - Electronic steering column lock control module - defective". I already opened this module and visualy everthinhg looks fine (not like the older one where one switch was damaged). I don't want to spend another 300€ for new unit, if there will be the same problem... I'm out of options so I hope that someone can help with this issue.
hi guys, can someone upload a dump from this EIS? it has a single cpu with 1L85D mask in my case i wanted to change vin so i erased it with CG but when trying to write vin or data back to the unit it always fails. sadly i didn't make an eeprom backup before erasing it
Hello.
is there a way to disable the EGR
EDC17CP42
After many solutions, the throttle is slamming - it opens and closes all the time with the engine off, and after starting, the revolutions jump. The adaptation does not work.
Just turn off the egr DTC P0486 and the throttle starts to go crazy.
help to remove butterfly box renault laguna iii hitachi mec92, could someone remove this dtc please, and correct the checksum, i can't, thanks a lot, read by obd with pcmtuner obd
Hello, I turned off the DPF and flaps, but the glow plug indicator does not go out. I disconnected the DPF pressure sensor and two exhaust gas temperature sensors.
My error is U0301 - Software incompatibility witch engine control module. I am sending the original file and the mod in the attachment.
Hi, everybody... i wonder if is possible to read ems s6 by bdm... i have original transdata but it is not recognized and bdm reads alll 00 and ff in micro.. does anybody knows how to bypass that protection? thanks
Hey all, Toyota uses a program called Engine Diagnostic Program for their 8 series forklifts. There is a usb dongle you must plug into the laptop in order to open the program. Has anyone gotten around it, or does anyone have one of these usb dongles containing the license key?
