|
|
Xprog clone vs. xprog original |
Posted by: Jan1980 - 11-02-2014, 01:24 AM - Forum: Automotive Hardware.
- Replies (3)
|
 |
Normally, I am happy with my xprog 5.0 clone. But sometimes, i have problems. For example, can't get connection with HC05X32. Do you think, an original xprog is the better choice ?? What are the reasons to go with original xprog ?
Sent from my iPhone using Tapatalk
|
|
|
C4 Mux Dead |
Posted by: MasterMaster2011 - 11-02-2014, 12:47 AM - Forum: Automotive Hardware.
- Replies (5)
|
 |
Hi Guys,
I have a C4 Mux here which is complete dead. I cant see anything on the screeen after connection with the car and the software does not recoqnise it as well.
Any advice ? Can anybody help me with the cable pin out schematic ?
Thank you
(yes, it is a mode in china version)
|
|
|
Delphi CRD2.3 pinout, is it possible? |
Posted by: marigor - 11-02-2014, 12:34 AM - Forum: Automotive Tuning.
- Replies (1)
|
 |
Hi, I take a job to do DPF off MB Sprinter Delphi CRD2.3. The first problem is best way to read it, i there a pinout for this ECU. I cant find BDM for it. I have galletto v54, Kess2, BDM100, MPPS 13.02, what is the best solution. Can I read it by OBD?
Second question is Swiftec good solution for DPF off, this is my first job for this dealer, and I dont wont to make mistake...
Thank you.
|
|
|
Galletto V54 Kline colour + Boot? |
Posted by: simmo490 - 11-01-2014, 10:49 PM - Forum: Automotive Hardware.
- Replies (3)
|
 |
Hi All,
Have a Galletto 4. does anyone know what colour the K line is? shows no Kline in the picture?
Also trying to boot a DCM1.2 but not sure if i should use the grey boot pin or to put the boot pad to earth via 1000ohm resisor? Anyone Ta
|
|
|
|