Hello,
As I know in many cases two chips are missing on PCB in VAS5054A:
- OKI
- TJA
Can anyone tell which chip in VAS5054 is responsible for support of UDS protocol?
Hi,
Need to find out how to remove immo on this Citroen Saxo 1.6. It is a Magneti Marelli IAW 1AP.41 ecu. It has a 28f512 chip with TMS374 processor. I can't get comms on this ecu from diagnostic socket so need to find out what i need to do. I have removed ecu and tried comms to front of ecu but nothing. I know car has had 2 ecu's fitted and think immo is locked.
I need to build an extension cable for esp button of my audi.
The connector has code 8L0971883 on etka: I need to find the female of this connector.
Can you help me to find one which I could use?
I attach a photo of connector which is actually used in my auto and where I should attach my extender.
+ More than 200 new PIDs, including flags (status PIDs)
+ Support for Mazda ISO PCM
- "Auto-increase" checkbox is now disabled by default (caused problems on bluetooth adapters)
- Crash bug happened sometimes on auto-increase on bluetooth adapters
- Bug with incorrect restoring Dashboard parameters
- Bug with cutting list of PIDs in Dasboard and Oscilloscope Setup dialogs
- Bug with empty list of tests (now the Test page is disbaled if there are no any tests available)
Morning folks....I got USA ford Tauras that i put used PCM in nd need to flash. I have done the flash but now the PATS system has kicked in and to get past it i need two keys....I know there wa s atrick if you had a valet key and an old pats key from something else, you tape the valet key to the pats key when you have to stick key two in and cycle it you use the valet key with the old pats key on it....but i dont have a valet key or an old pats key...i need a minumum of two keys to be able to program the pats system with pcm and i only have one...is there another trick i am missing or another way to get around this...the customer is up north and wont be back to get new key...i want to get this dang pcm in and running to get it out of here...
I install Xentry/Das 03/2012.
Das can connect to car. I used Part D4 interface.
But new car need Xentry to diagnostic, but Xentry can not connect to car.
Here are some picture of Error
THank u so much!
Renault Service Manual Reset Oil level ebook in pdf files,The lamp illustrated is an oil level low warning indicator and not a service intervalindicator.
Hello everybody. For a long time I looking for a wiring diagram Opel "Astra j". I have TIS2000 v.115 program and Globaltis V.32 - and in these programs do not have this wiring diagram. Do any of my colleagues know where I can find this diagram? Thank you in advance - Jerzy
Can anyone tell me,If im using ford ids software and plug in my gm mdi the head is recognized by it but im scared i may damage it if i change firmware,Can mdi firmware be changed to work on this??