I'm looking for a version of volvo impact that has the north american trucks. Does anybody out there have that? Give, sell, or maybe trade? Let me know guys.
Hello!
Have anyone program for Reset Airbag crashdata? The car is Ford Fiesta 2011. The Chip in Restrain Control Module is S25A32, The number of RCM is AA6T-14B321-BA.
Thank you very much.
Hello M8's,
I have big problem with Vito 108 2000'
Problem is related to immo,but i dont know what to do next,
car battery was flat a lot of times,because car crank but not start.
Check the ecu for errors and no errors related to immo,but in live data problem can be seen.I dont have "start error" on display!
In attachment live data from channel 5 and original dumps from ecu and wsp.
Has anyone had this problem and what to do next?
hello
I should make a total immo off on this machine Iud says to do so on the EEPROM 24C02 but is not in the ECU some say it needs to be done in flash can anyone help me
Alfa spider
0 261 204 484
12/1998
motronic M 2.10.4
Hi !
I installed Caterpillar Electronic Technician 2011C v1.0
I created an Activation ID: 0549-8754-1687-6498-7465-4979-7465-1687
Request :" Name + PC Serial Number "
Help me please !
Thank u so much !
In a couple of weeks I will be doing a rebuild on the engine. I am going to use a Comp cam lift 206/212 and going to bore and stroke it to a 383. Does any one know what kind of issues I will encounter with the PCM?
Hi mates, I'd like to share my problem and seek for help, maybe someone have already seen this problem before.
So the car is a 2002 E65 735i, the right doors were swapped by an other garage, they put everything from the old broken doors into the shiny new ones. The front passanger window now works in the opposite direction and only for 1 second each press on button from both sides. Initialization stops after 1s since the window starts with closing. ISTA says if the wiring is ok between door module and motor than change motor. Changed motor, same problem. Changed door module to used one without coding, still same. I checked the switch on driver's side, when I press close, ISTA shows close as well. Seems like the door module gives reverse polarisation to motor. I've seen on E70 X5 with uncoded new FRM worked like this. Is there any chance something coding needed? Or am I missing stg? Thanks in advance for any useful information! Geri
Hi
Got a ml270cdi w163 with start error on the dash
is showing as reading the key ok but
P1630-32 drive authorization incorrect authentication value
in the ecu
can someone make the attached ecu dump virgin so i can try and recode it to the car
its a 5p08 chip
