I would like to know if it is possible to tune my Toyota Avensis Verso´s ECU?
I have installed a tuning chip into it but it would be better to do it by reprogramming it with tuned maps.
Can anyone give any directions to whom to turn to? Does anyone know which tool supports these toyota Denso ECU´s?
I started this thread for members that have problems with BMW's that require some advise. Please guys this is not intended for issue's related to modified coding. I have been getting a lot of PM's asking me if I have seen or heard of an issue or if there is a bulletin/measure regarding the issue. I figured everybody can benefit from this info and solutions and so figured this would be a good place to post. If I can't answer as I am no BMW guru but I'm sure there are many enthusiasts or techies that maybe able to assist. Keep it clean guys this is to help everybody out there that may be experiencing the same issue's. I thought I'd try it and see where this takes us...
P.S
Please remember to provide enough info... VIN is the BEST way!! Post here first and if you don't want the VIN publicized then PM it to me and I will do my best to provide as much info as I can. If no VIN then provide... year, model, engine, trans, and prod. date. Thanks guys.
If I buy a genuine vcm2 but don't take a software subscription at present will it work with old software that I have already installed with programming or not. My original old rotunda unit will now not communicate with pc whereas it will still work on jag landrover. I have tried fresh install of ford software on other computers to no avail.
If I pay for subscription and it runs out what happens to vcm.
Hi guys,
I have a KTS 650 Celeron 400Mhz 128MB Ram.
There, I've installed Windows 2000. Touch also runs already.
Now I just need the drivers for the hardware diagnostics.
Who can help me there?
i have seen a few people advertise they can reset this fault does anyone know how they are doing it?
i didn't know that particular fault could be reset/erased
Hi guys
i i would like to cancel the DPF from this dump.does anyone help me.no success at Volta sensor
ecu Details
Mondeo 2010 years
SID 206
Regards
Ayhan
[attachment=30403][attachment=28292][/php]
Published: 2013 / date
Developer: Land Rover
Language:
Description: Spare parts - Land Rover from 1980 to 2013 inclusive.
Actor. Information:
There in September 2013 of the latest updates. Integrated multi-language interface
hi guys I have the solution for those who have placed sensor emulators BMW seat occupancy. I have the way to turn off the fasten seat belt light without having to connect. It is open the seat belt connector and remove proximity sensor. Put a small magnet with negative polarity and seatbelt warning went out. . It works 100%, tested in BMW E90 BMW E87 2005 AND 2007. See picture.
only have to open the casing surrounding the anchor belt and see the proximity sensor, do a slight pressure sensor off the back and now only have to place the magnet and ready
