I have a Porsche Macan with Simos 18.10 control unit. After the software update from obd, the car brought out errors on the catalytic converter and started to turn the fans continuously, at which point I understood that the control unit had already been modified in boot. Even though I solved all the defects it had, the problem continues, as if it had OPF regeneration in progress, without error on diagnosys. I tried in every way to solve the problem, resetting, adapting, but without success. Is there any way to virgin or reset the eprom??
Hi , i have swaped gearbox from A5 to Q5 , they are identical , except speed sensor ... Q5 dont have that sensor , so it shows fault on gearbox and puts gearbox into limp mode "gearbox malfunction" . My question is , is its possible to delete that fault the same way like from ECU ? Thanks
Hello
i want to delete immo in chevy epica edc16 . old ecu cannot be found
and all means to program with sps failed
ECU IS BOSH 0281013629
I have read map and eeprom to assist me in deleting immo .
thanks in advance
Hello everyone, my colleague at work drives a Dacia Duster 2015 and has a airbag light on. As i have a diagnostic scanner i tried to read out the error but we only get connection with the ecu and radio. i know that the scanner works and i also tried with renault clip but we could only see the 2 modules. i think the airbag light is also related to this canbus problem.Did someone had a similar or same problem and could help me out. What should i check first? We tried replacing the UCH but even with another one it isnt posible to read it.Any help is appreciated.Thnks in advance
hi all cracks here.
i have here a ligier js50 who not count and record journey , km are counted on trip area and change but you switch ignition off and on and disapear.
the bcm have a motorola mc9s08dz60 mcu i read it with xprog but i get verify errors sometime.
can somebody pls repair my dump put 27.000km or if they hace the content of the mcu please.
i can pay for the help always when i get the bcm repaired.thanks
Hallo i have a problem.
I tryed flash the ecu from audi a8 hw: 4e0 910 401H__0010 with odis-e.
I think i have a false flash file 4e0910401 H __ 0050.
I dont found this file with ending 0010.sgo
I hope somebody can help me i need this file with ending 0010.sgo
Hello.
I installed heated seats in a BMW F11 with modules and replaced the air conditioning panel. Everything works but the IHKA, SMBF, SMFA controllers have errors regarding incorrect coding 802C00, 802C03, 802A00, 802A03, 801211 801214.
I know that you need to add S494A Seat heating driver/passenger to VO and click CODE
But I don't want to lose the previous codings.
Could someone explain to me how else I can do this without losing the entire car coding?
I made back up all coding and VO. I edited SLAP element at position 494. Now I code each module on the list one by one?
I won't lose the changes I made to the car that were previously done?
I watched this tutorial and the guy says that if we code the whole car we will lose all the changes we have made so far
![[Image: dtc.jpg]](https://i.postimg.cc/W13PYKVv/dtc.jpg)
