I have problem with Twingo 3 radio, it on shows tomtom boot screen, and after that screen goes black, nothing shows on screen. No response from buttons. After some time, screen again shows tomtom logo, and again black screen.
Dear MHH Team,
I need an ECU backup for a Peugeot 407 2.0 16V RFJ, year 2009, with a manual transmission. The ECU model is IAW6IPB.
Please let me know if you can provide this backup.
Best regards,
Hi guys, I'm telling you about a problem with a 2019 Ford Focus 2.0 120Hp. ECU Bosch MD1CS005.
DPF off + AdBlue off has been performed, everything is correct except that after a few days the message "exhaust filter overloaded, drive to clean" appears. In the original file the DPF values have been reset and then the modified one has been written. I'm attaching both. Is it possible that my solution is not correct or is something else happening?
Hi,
I need to remove TPMS from opel insignia, 2010, with red display in IPC. I used SPS to download Calibration and XML files for this car. SPS updated BCM and IPC without any problem. When I use XML and Build files to configure BCM, DPS works ok, when I do the same to IPC, I always end up with "security access failed". Tried with Calibration files, made archives and I can write Calibrations to BCM no problem, but when I try to load Calibration archive for BCM, comm starts and I get security access error.
It can't be wrong XML file, as I downloaded XML directly for this car. With SPS it work fine, but when I select "no tpms" option in IPC programming I still have error in dash, so I need to remove it by DPS
hello. I need dtcoff for dq250, error code p170100, the immo was turned off on the second gearbox and I did not have access to the original information because the mechatronic was completely broken. The gearbox works perfectly but has this error. thank you..
Dear Masters, greetings to all of you.
We bought a clean used DVD90 Navi Tape to install in a friend's car, but unfortunately it does not have the code. I could not extract the code with the resources I had.
Can you help me with the code of the tape?
Good luck to all of you. Good evening.
Have somebody Original dash DUMP from Peugeot boxer 2.8HDI 94KW ? thanks. have problem after odo corection the vehicle speed not working good. maybe my prog take out bad and i write it also bad dump. or can someone check it please. thanks.
Hello. I need to disable the catalytic converter control in the Bosch me7.9.9 controller from a Chevrolet Captiva 2007 2.4L. Currently I have error P0420 catalyst system efficiency below threshold bank 1.
I plan to work with Vediamo ver 04 and 05 but at this point I do not know the path and folder for the various .ini files. The .ini files that i have are:
KurstestMercedes
KurstestPKY
KurstestSmart
KurstestVan
OBDWin
ECUGroups and
Services.inf
Any and all help with the correct path and folder placement for the above .ini files would be greatly appreciated. Thanks and enjoy your day
I have installed LED rear lights from a 2010 W212 to facelift LED. All rear lights work fine.
In my opinion, the two control wires for the inner rear lights of the brake lights (of the old LED rear lights) are no longer needed and are loose. Now it is logical that I get a message on my instrument panel Brake/Tail light left and right.
defective.
My question is which coding in SAMF (SAMR) should I change to get rid of this message?
Or does it need to be adjusted elsewhere?
