hi everyone
i have a toyota hilux with adblue problem ...it no start
i try resset and refill but no sucess ..i hve autel and launch but imposible
adblue off can be a solution
any help
Proud to offer Ram Cummins with 68rfe transmission no ecm swap required, Ezlynk, HPT, Efi live!
These are stock power emissions off files.
2022-2024 ram trucks
Hello guys, so i was working around with DTS Monaco on my amg a35 w177 to get the race mode to work with the Switches on the steeringwheel (driveunit), i may have messed everything up, as of now, when i try to rotate the switch it does not change drivemode, and on the left side, i can’t click it either..
would someone be able to help it?..
I have a problem with an Audi 48V, 2021. DLAA engine code,The car stayed 3 Month in parking.
the problems are: 1. battery light (yellow/red) on dashboard 2. faults in management battery control unit:0021 - Battery management 2 (battery 48V) : Number:
P1B1B00: Wear limit of main protection reached
Error type 2:
active/static
Symptom:
20516
Status:
10101111 3.Contactor can't be connected via ODIS-result: the contactor can not be successfully connected/End of test-No resolution 4.de-enerigezed/energized the 48 system with ODIS- made successfully. 5. SVM-odis -Online- -for all control units-all finished correctly. 6.battery 48V-removed-all its ok, fuse 200A-ok, contactor ok 7. how can I read/write:MC33771BTP1 and SPC58??? 8.generator was changed with the second hand one 9. all bus communication are showed like ok in Gateway. 10.SOC 12V battery: 100% 11. SOC 48V: 27% 12. basic setting in crash event done : see picture attached
I dont know how to solve this problem . can somebody help me with a next ideea?
Hello mates, my vas 6154a adapter doesn´t work any more. I can access the configuration, but when I try in odis to choose the vci as diagnostic interface the odis hangs and all LEDs on the adapter are blinking successively. In the configuration i can see, that the adapter has 2 boot options and the second one is invalid. Is it possible to flash vas 6154a, i thought it could help may be, or is it an electrical problem?
I don´t know how, but after 100 times i entered configuration the adapter was updated and now i again have 2 base systems.
The thread can be deleted.
Hello everyone, anyone can shine some light on the topic. I have a Toyota Avensis 2011 T27. The brake module has went. Ive taken it out and ive tried to find a second hand one on ebay since new ones are very expensive. I found one however Im not 100% sure if theyre compatible.
Both have the same part number : 46300-05010
My version is 10.2202-0137.4
The listing I found on ebay is from the same car apparently but the version is slightly different just by 1 number.
i have a sprinter where the ecu, keys, eis, elv have been changed by last owner because the eis got stolen.
the dash is the only thing that is still original so i want to find the SSID from the dash so i can write it on the EIS so the -------- will disapear for milaege and the SRS light will go out.
3.2L ranger with a DPF delete attempted prior to me looking at it. P20CB and P269D active. The aftertreatment injector and glow plug have already been removed elsewhere and they cut the wiring harness and put the parts in scrap bin apparently.
Can anyone confirm these codes can't be removed and resistors/sensors need to be connected?
Trying not to waste time getting sensors, finding cut wires if it's not necessary 👀
Hello good morning.
I need to demobilize my 320d 136hp.
This vehicle has edc15M and I have not found anything about it.
At another time I have successfully unmobilized edc15c4 but in this case I can't find anything about it.
Hi everyone am here to change msv80 to e70 i have dme Isn need to match with cas module ...can anyone help identify Cas module isn via dump here down ..any response much appreciated ...attached here down Cas file eerprom
Does anyone have or can recommend where I can get ORI flash software for a Bosch ME7.5.10 0261S04176 I'm using KTag. I stupidly lost the dump
hope I'm not hi jacking a thread here
