Car has turned up with new pump, says coding issue on dtc. Odis telling me that:
Hardware requiring checking was detected! ire dre SVM detected that the control unit 03 - Brake Electronics is not valid for this vehicle! - Check whether an SVM code
Can someone tell me if i need an svm manual code or a different pump?
hello friend's
let me explain the problem:
The car has difficulty engaging first and reverse gears when the car is stationary and when downshifting 3>2>1
when downshifting in Tiptronic mode, the problem does not occur
If I brake slowly, the problem rarely happens
I have error P2711, the basic adjustment of group 061 and 060 are carried out successfully
attached images show 3 attempts to engage first gear and then the mechatronics goes into emergency and error P2711 appears
Hello guys. Can anyone help me with Hino 268 2009 my denso ecu dpf egr off without reset. The truck has been deleted before but the idle rpm is high with idle rpm is okay.
The immobox is lost so now I am trying to do immo off with unican, but after do the sync bytes still blink in red.
I think the 4 sync bytes were the previous of FC 24 but i don´t remenber now.
Attached the mcu read and the unican eprom.
Any help will be gratefull.
Hi, I need a guide to lower SPC213 using DTS Monaco. I paid someone to help me and I forgot how to do it. Will pay again, just want to know what to change. I have seedkey calculators, and all required files.
Have a 2017 Volvo V70 here that the CEM got fried on. MCU R5F64525 has an internal short on VSS and VCC pins. No way to read it to clone. Another chip on the board also got burnt.
I have another CEM here with matching part numbers, wondering if anyone has ever adapted a used CEM into one of these or can recommend a tool that is able.
i accidentially bricked my VAS6154 (VCX-NANO) China Cracker with Firmwareupdate to 1.9.6.0 and now my Odis doesnt recognize it anymore and always says that the is invalid.
I want to do a Firmware Downgrade, but how is this possible ?
I have a problem after DPF off, Caddy 2.0TDI DFSD EDC17C64.
The car after a few seconds after pressing the full throttle, turbo charges max 0.4-0.6bar, and after a while goes into limpmode, it shows error P0299.
Sometimes when I stop the warm engine, the fan still works for several seconds.
I have m550d F11 03/2013, instrument cluster is 6WA I try to activate M550d logo in cluster but dont have options. Maybe need to update iLevel
I have Autel and J2534
Can I update only Kombi module?
![[Image: 93750a63995a80b9c7bba1de5469ac4b.jpg]](https://uploads.tapatalk-cdn.com/20241007/93750a63995a80b9c7bba1de5469ac4b.jpg)