I've issue to remove the w205 glove box lid, please help to advise how to remove the pin from the box and special tool need ? Thanks a million for you help.
Hello, I have a Mercedes W218 and I need to reset the AdBlue counter. I have OpenPort 2.0 and Vediamo installed but I don't know the correct procedure. The work will be paid for.
Thanks
I have problem with conversion mp/h to km/h in Durango 2020 (US market). After change to km/h radar go to plant mode and i can't start radar calibration. I tried change destination country to EU, Germany, etc. and its not worked. When I back to USA market plant mode gone but km/h too. I used AlfaOBD, maby somabody have solution for that.
Thanks
A while ago I bought a decoder for my Mercedes so I could have Android and Android Auto. My touch screen broke and recently the GPS antenna cable broke. I found the following store on the internet, https://www.dvdgpsnav.com/ which appears to be very good. I agreed by email to pay $140 for the two pieces. They do not accept debit cards and they ordered me to make the transaction with Wise in that currency, since I use €. The transfer was made and they say it did not reach them. And we had to argue with the bank for $140, and even after a month they are still lying. They are scammers! Please spread this, because it is a pirate and scam company. The website is https://www.dvdgpsnav.com/. Don't buy and refer in another web pages. They are scammers. The transfer arrived on 16th September. They are thieves.
hello, I have a problem with the vehicle and throttle response, I have always been troubled by slow throttle response and response. today I noticed that if the car is stationary or I hold the clutch while driving and the gas reacts beautifully, but if the car is moving and I have neutral and the clutch must be released, the reaction is horrible. Does anyone know how it is different in this file and could make it so that the recitation is always fast?
Hello,
Can someone help me to find eeprom in this control unit for Suzuki gsxr 750 K7?
I try to find by manual from EFfi and one more picture but without success. I need to read eeprom because I have all key lost.
Hello guys, I have been scammed in this forum, I asked for a tuning for my Audi A4 B5 K04 and a guy from this forum was offered. I sent him the money and he sent me a file that does not work and now he does not respond, my car does not work and he I am out of money, can someone help me? I can't use my car the user is dopmotorsport
Have been struggling with the car which I bought 3 months ago. First, it had a head gasket issue, where it had been split between cylinder 3 & 4. Yet engine was able to run with a bit of a black smoke.
So I changed the headgasket and gave cylinder head a full refurbish and check for leaks. It is basically like brand new with some material removed from the surface, which was compensated by thicker headgasket.
The problem is, that the car until approx 70C degrees warm, gives white diesel smoke (certainly a diesel smoke which is very distinguished). Car is misfiring sometimes, and when You accellarate, engine is very loud. (nothing is really taping and hitting anyting, it seems like a really rough diesel knock or incomplete combustion).
It seems, that the car is overfuelling a lot. There are no faults in the ECU. Compression tests, both in xentry and with manual test are reading good, there were no signs of damage in the engine, when it was apart. Even the honing on cylinder walls was still visible.
I have checked the injectors in 2 different shops, they all came back good. Hovewer I still was not sure, and changed 3 of them , but nothing is changing.
Correction values for injectors at idle are in between +- 30 . (Limit as I understand is 68)
Smoke is definetly unburnt diesel, and I am not sure where to look anymore, as I believe, I have changed every single sensor. Also changed the glow plugs, but not the glowplug relay.
I have noticed that at Idle, MAF Sensor ir reading between 550 - 620 which seems a bit high for 2.2 diesel ? Not sure actually, everything on xentry reads in between normal values.
Any similar experience, tips where to look, would be really appreciated.
I have just replaced the alternator. But it isn't charging the battery. When I checked the contiunty between alt to b+ there is no connection. So I gave + to alt with external cable so alt starts to giving 14.4v. I have searched on internet some peoples fixed the issue with fuse that under the carpet of passenger side. But there is no fuse in my case. Also someone fixed the same issue with fuse it is on the cable which is between alt and starter motor, but i could not see that fuse when I even removal the starter motor.
I need help of a who has experienced the same problem. Or anyone can find diagram of the alternator for this car?
wiTech MicroPod 2 for Chrysler, supports the diagnosis, with Multi-language, and provides 100% CAN coverage for Chrysler, Dodge, Jeep, and Fiat.
wiTECH MicroPod 2 Diagnostic Tool Highlights:
1. Latest Software: V17.04.27 to 2018 (free)
V6.15 CDA ,2018-2024
2. Best firmware version that fix problems
3. Multi-Languages supported: English, French, Spanish, German, Italian, Russian, Japanese, Korean and Chinese
4. PC-Based: Requires PC connection
5. Must connect to network to work, otherwise will prompt you to activate software.
6. Operating System: Windows 7/Windows 10
7. Tested by lots of clients that an online subscription to TechAuthority can work with this MicroPod II.
8. DRBIII Emulator is well tested by many customers
9. If need to diagnose Fiat Lancia and Alfa vehicles, need to order Fiat software.
wiTECH MicroPOD2 features:
* Supports all the latest technologies and vehicle platforms including the latest Chrysler and Fiat Vehicles.
* Works as a direct replacement for the wiTECH POD
wiTECH MicroPOD II model year coverage:
Although small in stature, this dongle-style device offers 100% CAN - equipped coverage to 2018 for Chrysler, Dodge, Jeep, and Fiat vehicle platforms.
wiTECH Software function:
1) It can be used as diagnostic and programming tool by the dealerships. Replaces your StarMobile, StarScan, and wi-TECH POD,provides world-class diagnostic services to your customers.
2) A separate Tech Authority Subscription is required to access to Module Re-Flash Programming, TSBs, wiring diagrams, and repair information.
$129 To Get One V17.04.27 wiTech MicroPod 2 with CD>>>
If you need the latest software V6.15 or want to know more details, feel free to leave your comments or send us a message.
![[Image: WiTechMicroPod2WiTech2ForChryslerDiagnos...&width=600]](https://www.vxdas.com/cdn/shop/products/WiTechMicroPod2WiTech2ForChryslerDiagnostic.png?v=1713511705&width=600)