Hello, I made a hardcut in my e93 m57. Using the hardcut v2.1.1.1 program. Set to 4000rpm, it only works when driving when I put it in Neutral. The problem is that when I'm standing still, the engine cannot exceed 4000rpm. Can someone help me remove the factory limiter in neutral gear? Or make a section and hardcut. I'm a beginner, I can pay . I'm attaching the original file without hardcut.edc16cp35 e93 AT
Hey,
I have question about voltage in egr connector.
Peugeot 508 2.0 hdi, DW10BTED4 RHF
It is possible after disconnect conector from egr valve they have 5 V on the signal pin?
Hello Guys, i am having an issu reading the eeprom 24c32 on a VW MFD2 BN0 881 when i am triyng ro read it carprog show me an error "Verify ERROR" the wiiring seems and the radio is on can you guys please help me Thanks
I have trying to repair rear sam of 2009 CLK. The owner of the vehicle burned the modules by connecting the vehicle's battery to reverse polarity. When I opened the module and looked inside, I found that the VND830 sheathed chips were burned and soldered new ones. Now, when I connect the module to the vehicle, the relays on it constantly turn off and on with inconsistent timing. Have you ever had an experience like this before? How should I proceed next?