hi. mini cooper s 2007 , med17.2
after write the car dont start. can anyone check this file ? getting checkum error when reading the file again. rather getting no contact with ecu when diagnostic .
thanks
hi, I need your help forum friends to extract the pincode from the fabia 1.2 cluster, dash SN: 5J0920 810E
eeprom 24C32
Thank you for your helpful help.
I have a problem with the bmw g05. Auto after replacing the bdc and atm module. In the car, traffic lights and priority signs were displayed on the odometer earlier.
I used the encoding from the file below. In the navigation menu, there is information about traffic lights and other assistants, but it does not appear on the meter.
Here is vin my car WBACV01060LS85876. Now I-Level is 24-07.
Hi i need make immo off in ecu edc17c64 for VW golf 7, have no oryginal ecu. I have correct ecu for this car but maked immo off in flash and have SAFE on dash. It is possible make immo off without Safe. 04L906021M
Hi does anyone have a good solution for DPF egr off on Volvo loader l150g its TRW 2.2 ECU i paid for 2 solutions but on both DPF light came back in the cab and IT count down hours back to 0 engine Light is on no power....
I have read this opel 1.3mjet, mjd603 ecu, would like to check map, becouse i think someome has done something to it. Tried manulay to find addresses but with no luck. Can someone extract map adresses for this ecu ?
Hello everyone i have a w222 2019 hybrid which diagnosed the hybrid control module failure, however some experts to me that this unit may contains anti-theft info inside, and cannot code it with aftermarket software, please forgive my basic understanding of automotive electronics, may anyone provide me some advises?
[font=Roboto, "Helvetica Neue", Arial, sans-serif][color=var(--YLNNHc)][font=Roboto, "Helvetica Neue", Arial, sans-serif]Hello, I will probably need to clone sid206 Ford kuga .5WS40583G-T. Can I replace it with a controller with a different end. Part number: 5WS40592J-T EU2J SID206 or do I have to look for the same number?[/font][/font][/color]
Long story short, have a FRS here, way too much work done. It has DTC P119F, P119E, P219A. At the moment it's not worth trying to work on it some more, and these are just the only code that keeps popping up.
ZA1JF00C calibration.
Read with ECUflash, but neither ECUflash or romraider has the option to delete P119F, P119E. Only P219A.
Would like to see if possible to delete both 119E and 119F, in addition to P219A.