Hi members i need on this eeprom dumb from Nissan Juke from ecu ems3155 mileage correction to 93231. Can somebody do it or tell me how to modify this file or what solution there is? thank you!
I recently installed a preprogrammed conductor plate on a 2011 Gl450. I was able to activate the TCM and marry to the car as per the instructions it came with, but it fails to relearn shift position due to communication failure after learning “park” and therefore will not start. Attached are the codes it is getting. I appreciate any help.
We did test on heavy modified EA888 Gen3 engine running ethanol and 2,5 gauge boost - installed 2 levels colder plugs + dwell 3ms flat, gap 0,6 mm. Car used hard for 5000km. Results was predictable - higher dwell melted center electrode slightly, soot on plug reflected it was too cold to be heated burn it off. Subjective observation - idle was bit rough till engine fully heated up. We installed stock plugs and stock gap - on same setup - we did not noticed any detonation or issues caused by stock plugs on high load. Will see results after 5000km.
Lessons we learned - way colder plugs are not mandatory on ethanol mixtures, dwell mod was silly idea....
I have a mercedes V class. V220 that keeps smoking even after trying several solutions. It has a white smoke then somtimes black. Like its regenerating. I am willing to pay for a working solution. I have seen its a common problem. I have already cleared dpf data , scr data . Disconnected adblue, disconnected egts, differential sensor.. Same results...
Hi, I'm trying to Immoff this ECU from Renault Kwid without success, I tried the IMMOFF17 software posted here but the car activates the starter just once and the engine did not start and then it no longer activates the starter. So I'm interested in a working immoff solution...
Can someone explain me what a Bosch 40331 is doing? Is there a Pinout available?
My Problem is that the marked Pin is a switched GND. But it doesn’t switch.
When not triggered it has 2.2kOhm -> GND and when triggered 1.6kOhm.
But it’s a Relais on the other side that won’t work without a proper GND on switching side.
Just got a clone of kess and i was trying to delete the egr valve but i couldnt find my ecu on the softwere
Anyone tried or used kess clone on a car like that
Hello, I have to delete some DTCs and with the software I can't or can't find them, I only managed to delete one and I'm missing two others. P1922 and P1932.
If anyone can help me with this I'd be grateful
Greetings and thanks in advance
Hello,
can somebody please check whether this post-cat lambda solution is good or even if its actually done ?
Audi A8 D2 4.2MPI V8 310hp
ME7.1.1
4D0907558T 0003
1037360180
Kess OBD Read
Thank you very much
