2000 330i m54 e46 no start after crank sensor changed no fault codes stored but does not read rpm in live data, unplug the new sensor it will start and run OK on the camshaft sensors and set fault code for crank sensor 000053 i have ordered a new oem sensor to try has anyone had this before.
Hello, I am asking for recomandations regarding a decent mileage correction tool that works on cars like BMW (E - F chassie, or even G if possible), Renault + Dacia (Dash + ABS), VAG (Johnson Control Cluster especially), etc.
I already own a DigiProg 3, OBDProg M500, CarProg Clone.
I know that there is the obvious option like SMOK, but I am askig for something that is a bit more friendly on the price, as 4500$ for a SMOK is quite a lot of money.
Thanks.
I have an Audi A6 4F 3.0 TDI from 2007. I have problems with the gearbox and the vehicle jerks when accelerating slightly from 1000 to 2000 revolutions. I read that an update of the TCU can fix the error. I have VCP and VCDS.
I found this file. Is this an update or do I need another one. Do you have to pay attention to anything when programming? Immobilizer or something else.
Hello , i have not ignition this car error 05 module its :02811 Steering lock defective. BCM2 module its number 4H0907064AB. Read VVDI PROG P-Flash and D-Flash. This module its not EE 95320. This read file.
I have passat b7 and have fault in gearbox P189A Clutch 1 clearance too small.Clutch replaced to new.Now I want to update software and I need sgo file by VIN WVWZZZ3CZEE133520
Hello, can someone help in removing the second lambda probe so that there is no error after removing the catalytic converter. And in removing the error from the SAI P0411 pump. Audi a4 BEX 8E0909518AS
Hello, i need someone who can do coding remotely for seat ateca 2022 after replacing an 13- ACC Module i got the component protection dtc in both the gateway 19 and the ACC 13
also the coding from the front camera unit is needed after replacing the ACC
19- Gateway component protect
13- Component protection + coding
A5- coding
i have odis 23.0.1 and a passthru device
thanks
hello,
may i ask help for e class e350 276.957 engine.
So when start engine, fan is start 89% (in ign not start fan).Xentry not see dtc in engine,collant temp is ok,but engine temp is 105 celsius in cold engine!
i change engine temp sensor behind left head,same result.can someone help me and explane what to do ?
Hello, I have a question about reading the mcu, you need to solder the a7 adapter, my question is the pinout from x-tool, there are 2 black arrows, and the a7 adapter has only one black wire, my question is whether there are 2 arrows because it doesn't matter where it is soldered to?
Hello after several solutions tried I still have the light on the dashboard with written blocking 0km but the car starts if you have a functional adblue off solution thank you md1cs016
