I have a question, has it ever happened to you that the W176 car without a steering lock because after turning off the ignition the steering wheel does not lock, an error is displayed and the car did not pass the technical inspection, of course it does not physically have it, but it worked before the failure and there was no error
Hello,
I'd like to learn if using Witech Micropod II I can make backup of my BCM which has been flooded and then flash this backup into used BCM with a different VIN number. Is it possible with the use of Witech or maybe I need a specialist programmer?
Thank you in advanve for your help.
i tried to clone with pcmflash after writing flash ecu is locked and can't revert back anymore on bench, communication is ok
but whatever i try i get this message...
Entering reprogramming mode
Waiting for ECU to become ready
Connecting to ECU
Passing Security Checks
ECU is locked. Can not continue.
Completed unsuccessfully
so, i need full KTAG BDM for this ecu
0281010565
SW : 361858
Hi everyone
i wanna someone remove dpf and egr from this car vag md1cs004 i make it so many times and it have a same problem on egr don't able remove so can someone make it good way and good sulotion work 100% because i tried so many tools
the file here https://limewire.com/d/ead279a1-39c3-499...Jvbx-NUj4I
thanks
"Hello, can the VNCI interface safely remove Component Protection (CP) using ODIS 24 without any risk of damaging the vehicle's modules? Thank you for your answers!"
Hi, can someone please help me with this files if its corupted or not.. was updating the ecus but in cas it stop with error. now nothing work. the car is dead. Cant do reflash with WinKFP even Tool32 doesnt identifi ecu. see here on forum that its just repair the file and write or its something more ? thank you.
Hello.
Im looking for original toyota yaris 1.5 hybrid file:
Calibration: 30DY0000 A4701000
Calibration file: 89663-0DY00
Hardware: NHP1## 1NZFXE
Part Number: 89661-0U230
Cant be read because of metal box ecu without programming pins.
Hi! I'm not sure if anyone can help me or not. My electronic steering lock unit has gone bad. Can someone remove it from BCM2 files and the car work? I have ACDP in order to write files to bcm. It is an unencrypted chip. Any help is appreciated!