I have passat b7 and have fault in gearbox P189A Clutch 1 clearance too small.Clutch replaced to new.Now I want to update software and I need sgo file by VIN WVWZZZ3CZEE133520
Hello, can someone help in removing the second lambda probe so that there is no error after removing the catalytic converter. And in removing the error from the SAI P0411 pump. Audi a4 BEX 8E0909518AS
Hello, i need someone who can do coding remotely for seat ateca 2022 after replacing an 13- ACC Module i got the component protection dtc in both the gateway 19 and the ACC 13
also the coding from the front camera unit is needed after replacing the ACC
19- Gateway component protect
13- Component protection + coding
A5- coding
i have odis 23.0.1 and a passthru device
thanks
hello,
may i ask help for e class e350 276.957 engine.
So when start engine, fan is start 89% (in ign not start fan).Xentry not see dtc in engine,collant temp is ok,but engine temp is 105 celsius in cold engine!
i change engine temp sensor behind left head,same result.can someone help me and explane what to do ?
Hello, I have a question about reading the mcu, you need to solder the a7 adapter, my question is the pinout from x-tool, there are 2 black arrows, and the a7 adapter has only one black wire, my question is whether there are 2 arrows because it doesn't matter where it is soldered to?
Hello after several solutions tried I still have the light on the dashboard with written blocking 0km but the car starts if you have a functional adblue off solution thank you md1cs016
Hi guys,
I have a audi a5 with some strange problem, one day car just cut off, and all dash light come on, long story short its common problem with bcm2 module, so I ordered 2nd hand one, same part numbers sw and hw matches, after that I find out its really hard to clone it, basically I need to repair dump (thats what I think). Can vvdi repair dump or read full dump?
Can someone please explain me can I clone it or just repair dump in original bdm(no water damage) ?
Im planning to buy a vvdi , but to get vvdi2 I cant buy right now(too expensive).
Btw car starts once, and after switched off, ignition stays on, and no feed for ignition relay, tracked black/white wire to bcm2. And fault in bcm2:
Control module defective, no communication with airbag, and few more
Hello I have this bsi it's a Siemens bsi have problem with right blinker in front don't work. If I put another bsi it's working. I have tried virgin 2 other bsi and learn key but have errors I can't delete and I don't have diagbox.
Then I tried to change top board with fuse and relays but same problem, so I think blinker is controlled from main board.