I am attempting to reflash the Cruise Control Module (CCM) on a 2015 Jaguar XF (X250). The car did not originally come with a CCM and I am attempting to retrofit it. All physical work and CCF edit is done, now just need to sort out the SW/calibration - I was told the module was from a similar XF, but it turns out it is from another Jaguar model, hence why I would like to attempt a SW reflash with the correct one -, but I am stuck.
On SDD there is only a 'Configure New Module - Speed Control' app available, but all this does is attempting a VIN learn, then setting the CCM into calibration mode.
I would have to run the 'Configure Existing Module - Speed Control' app, but it is not in the 'Service Functions' -> Recommendations list. In fact there are no 'Configure Existing Module' apps at all.
Tried with both SDD v138 & v165.
When I am using the 'Softwaredownload.html' in the JLR/SDD/Runtime folder, there is an option to run the 'Configure Existing Module - Speed Control' app, but whole place seems a bit sketchy, like there is no real comms to the car. Here, I am getting a 'cannot resolve part numbers' error - as per the attached image.
Hello ! The car is Audi A4 B7 1.8T BFB engine manual gearbox.Old ECU is water damaged.Now ECU is replaced from same car and engine but automatic gearbox.Immo adaptation is ready and engine work.ABS,ESP isnt work because donor ECU have TCU communication error.How to made variant codinfg for manual gearbox ?
Hello.I need help to change region on Japanese vw t-roc imported to Europe(for Fm frequency).In 5F information electronics which byte i will need to change?
Hello everyone,
I am currently working on a Citroën Berlingo B9 (engine 9HX) with a Bosch EDC16C34 ECU. The vehicle has an immobilizer issue, and I need to perform a reliable immo off solution.
Using a KTAG interface, I have successfully extracted the following data from the ECU:
EEPROM dump
Flash memory dump
Both files are attached to this post for reference. I am looking for a tested solution or a validated method to disable the immobilizer on this specific ECU. If anyone has experience with this setup and can guide me through the process or provide modified files, it would be highly appreciated.
Thank you in advance for your expertise and support!
Hi, i have tried to read an A3 1.8t 2003yr 180hp... Me 7.5 selected by menu, dash on, click on ECU id: no information Why? how is possible? very strange. mpps v18 brand new
hello friends, in my garage now is renault koleos 2013 with diesel engine and automatic gearbox . with electical issue. if i connect battery , car turn ignition itself, but cant start engine, cooling fan runs, many fauls on dash, somonetime turn headlights itself also. i cant turn off ignition with start stop button. i checked voltage to modules looks normal, diagnostic tool cant connect doesnt see car,
maybe problem is bad upc ? sometime engine wil start after many many attempts. i dont have time today to check this car, but i need info what i can check tommorow.
