Hi there, I need an EGR and DPF delete on my rav4 file if possible. Willing to pay.
The map that the vehicle came with i suspect someone did a bad job on it and only deleted the DTC's/EML from showing but still slipped into a low power mode, now that I have put it back to original file it throws EML with p0400 error also with same limited boost performance, so im looking to see if someone can do the job properly for me.
Details from kessv2 ID - which is what i used to write original sw back onto it
[font="MHH Font", Calibri, sans-serif]Hello everyone. I need to update with last version or other the tcu of a Golf 6 1.6 diesel CAY with temic dq200 electronics. [/font] [font="MHH Font", Calibri, sans-serif]Gear Id MGN[/font] [font="MHH Font", Calibri, sans-serif]actual sw 0AM300048P 9060 0694A600AM getriebe DSG OV4A[/font] [font="MHH Font", Calibri, sans-serif] I repaired the mechatronics due to the classic pressure problem and I would like to load a SW version which brings the accumulator to a lower operating pressure.[/font] [font="MHH Font", Calibri, sans-serif]Do you have any suggestions on which version to upload?[/font]
Hello everyone. I need to update with last version or other the tcu of a Golf 6 1.6 diesel CAY with temic dq200 electronics.
Gear Id MGN
actual sw 0AM300048P 9060 0694A600AM getriebe DSG OV4A
I repaired the mechatronics due to the classic pressure problem and I would like to load a SW version which brings the accumulator to a lower operating pressure.
Do you have any suggestions on which version to upload?
I have tried to do DPF and EGR on this Volvo but it emits a lot of white smoke, it seems that it wants to regenerate accompanied by jerks.
The ADS Remover solution does not work.
Can anyone help me?
Thank you very much in advance.
All the best
I want to share with you Odis E 18.2.0 with licence, launcher, postsetup
project files can be grabbed from earlier releases of ODIS-E Its not my release so use patch on your own risk. I have tested it and all works
Thanks goes to the original author of the files.
Send +1 rep and thanks for password and send me PM when done.
NOTE! NO Support for VAS5054 in this version so DONT! write me any PM regarding this, they will be deleted.
Hi guys, can you check if any of you can find this ISN ISN:610B8CC4C633B0653BAB31A65F76480D on the files attached, this is a full read with FC-200 from 8hp70 BMW 550i I'm trying to figure out where the ISN is stored, manage to find the VIN but not the ISN
Hello everyone. I am looking for a 100% immo off solution for Renault Master 3.
ECU: EDC17C42_C1767
HW: 0281019382
Serial number MCU:4180080C-0B208C89-74080010-11140600
hardware number MCU: 00001820-00009001 0053C001-00000000
The antenna is broken and there is no way to get the car out of the parking lot.I need to disable immo to get a car. Thx anyone. if you have a one hundred percent solution and it costs money, write to me. I only need a 100 percent solution.
Mercedes S-class 350d 2018 W222 6 cylinder inline engine. Problem with interior Heating,
The front air vents are blowing cold air & the rear air vents are blowing hot. Brand new “heater control valve” & “switch over valve” genuine parts from Mercedes and still the same problem, NO codes in diagnostics, i have bleed the system still the same problem. I have re-learned all actuator motors for air-vents and still nothing Any known fixes for this??
Hi all.
Is there some manual what parts needed to retrofit adaptive cruise control?
I have intelli safe, blind spot, lane keeping, road sign, high beam assist.
I've got VW UP 2018MY with battery discharge problem. I found that Central electric (09) and Can gateway (19) does not go into sleep mode. Even after few hours current meter show 0,150ma power consumption.
It's look like somebody have played with long coding.
Actual coding is:
62A02B0000010000000000D0688928D07940708D00CF0D280101000B0800 (30 Byte bornetz)
Can gateway:
001201
Anyone can help decode all bits? I'm using 24.7.1 VCDS but there is not full description for that unit.