yhello guys
i bought a bcm and it has security code not divorced so i bought clone iprog. i did solder according internet picture i am not sure it s correct but it did not work out: i have welding line but i am nott sure it s for iprog. Can you give correct pinouts for this bcm? thanks BCM code is;FT
I have a water damaged SID204 that im trying to clone, i have a donor ecu with the same numbers ready to write.
The read i have from the damaged ecu wont save the FLASH due to a ck error with ktag, guessing its a mod file, i do have EEPROM and MPC though. I have a full read from my donor ecu but when comparing the eeprom data it looks very different.
Please can i have help with suggestions of how to get around this issue.
Ive noticed the FLASH contains the vin as does the EEPROM.
hello good everyone
I have a BMW 530d 218cv with a 6hp26 box but it is very bad, they offer me a 6hp26 but from a BMW 330d 231, would it be compatible?
If I assemble it, would I have to code something?
I have xhpflash paid, if I change it with reflashing xhp would everything be fine?
thanks in advance
Hi,i have a 2007 passat b6 2.0 TDI BKP,When i want to start it, It starts very bad but starts no fauld codes on vcds no injectors high values etc. After leaving it 10 min after i drove it it starts again bad,But if i stop the car after i started it,it starts good,Any clues? here s the bin if you want to have a look at it
Hi guys. i have on bench BCM fro jag xf DX23-14B471-AG MC9S12XET256. Problem i have is when attempting to read Dflash( as i want to clone it) it throwing error of sectors empty.
underneath message from Xhorse multi prog.
[ p, li { white-space: pre-wrap; } Buffer D-FLASH does not support validation! Initializing device... DB44 interface inserted Pin configuration completed Power setting in progress... port49:0 mv,port50:0 mv,port51:0 mv,port52:0 mv port53:0 mv,port54:0 mv,port55:0 mv,port56:0 mv vcc:0 mv,vdd:0 mv,vpp:0 mv Chip power configuration modified successfully! Chip power turned on Writing chip configuration information... Attempting to set crystal frequency to0x00000000 Set crystal frequency successfully! Chip configuration all successful! Querying chip basic information... Chip connection succeeded! Chip ID detection in progress... Chip ID detection succeeded! Chip ID is:1M53J|2M53J(C081) Chip unsecured Reading partition... Partition informationFLASH: 0 Sector(0K), EEPROM:8 Sector(2K) Start reading bufferD-FLASH Read length is 0, stop reading Ending process The chip power has been turned off!]
BCM Working when plugged in however i lost ac controll and reversing sensors due to corrosion and previous owner drilled holes in pcb board to jump cables hence replacement. I would greatly appreciate for advice of what am i doing wrong. thanks
hello .
Jumpy error P15a0, car does not have an original oil pressure sensor.
Is it possible to disable the strategy?
DTC off didn't solve it.
The vehicle loses power after a few km, it starts well and takes about 3 km to start limping.
FLASH: 0 Sector(0K), EEPROM:8 Sector(2K)
