Have ms42 and made ews off on ecu.
Now car starts but fault A9 throttle body came up.
Tried correct checksum with lsuite, mpps and ultimo. All say checksum correct.
Can someone check that file is ok and chks are ok?
Greetings to everyone. Does anyone have any experience with editing the Kia Stinger PCM file using BitEdit and reading/flashing with BitBox? Most specifically in deleting the Vmax speed limiter imposed on the models with 18" wheels. I'm considering purchasing the BitBox and BitEdit software and matching modules for this model but in the details it says Limiters (If Found)
Hi,
One day, in my clip v231, the message appeared: "License expired! Available times 2. Please update VCI",
I uninstalled clip, cleaned the registry and deleted all folders, installed it again, activated it using "Renault clip tool v2.6 by Mrorry" with a date to 2029, which went through successfully, But this message still pops up and nothing can be done.
Any advice?
I own a 2020 Nissan Sentra , the electric steering rack is bad , excessive play where inner tie rod is attached, It had the recall done , but the rack has internal play , bought a used one and now the stealership says you can only replace with a new one WTF. I can get Consult3+ , but the stealership says still there is no way o get a used one to work, I call BS , but if this is true can I take the electric part from my wrecked rack and install it in the good used rack(27 km on the wrecked car hit by plow truck on sales lot) , or do I just use Consult3+and followed procedure for replacing with new
Any help will be greatly appreciated
Hey
Can I ask for help in obtaining a starter key for Xentra 03/2020?
software 26.9.3.2
HWID: 43C5DF3BA6B5
APPLICATION: 252
I lost it after updating the system. Please help.
[font="MHH Font", Calibri, sans-serif]Hi, I'm Andres and I need help with this file.[/font] [font="MHH Font", Calibri, sans-serif]Anybody here able to make DTC off for subject, please ? [/font] [font="MHH Font", Calibri, sans-serif]Need to get rid of P179E and P179F.
[/font]Thanks a lot
hi i have a kubota with denso ecu need hours correction on this ecu ... have around 6000 hours and need 3125 thank you my carprog is not working again ... https://easyupload.io/rhwfm4 here is eeprom
Hello everyone, I leave you the map package that I am trying to finish and complete in case it helps anyone.....it would also be good if someone sees something wrong or wants to add maps that are missing many to say so since I am new in this and I do it for a hobby and for the personal use of my car, this is not my job......regards