I've got Xhorse VVDI BGA and i programmed an emulator for the failed ELV. Everything looks good in MB Tool 5.1.6, but once i connect the EIS and emuator to the car (with nothing of the steering column connected), there is no life when turning the key around.
From my OBD scanner, i can see that EIS only registers the key insertion and nothing else, but it did it prior to the removal of EIS and emulator programming.
On the bench with laptop running MB Tool, i can see from "test key" functionality that all the correct ticks are in place as i turn the key to position 1, 2 and starting the engine.
I did program the emualtor at least 5 times, initially with wrong password before buying token and getting the correct password.
What do i need to do to move forward? Could EIS also be faulty now?
Appreciate any feedback, thank you!
Update#1: after first attempt at the car, i also wrote EIS with VIN that it was missing obviously.
Hi everyone, require help/direction with either cloning or virginizing a second hand ECU.
I have pulled the original read EEP/EFlash/IFlash and also have the same from the donor, if possible i would prefer to clone this ecu as it contains a tune/dpf delete and the new one will not.
Read was pulled with Multi-Prog, I do have a slave Autotuner and Kess V2/Ktag if required.
Fuel pump replaced, because its electronic was burned.
Pump replaced, but got two dtc's.
DTC 46 DDE: Control unit, injection pump (communication)
DTC 49 DDE: Speed sensor, injection pump
Got an ecu with same part number: Bosch NR: 0281010205
First replaced just the eeprom, but no start with immo fault code.
Then replaced both flash chips too, and now got immo and the two dtc which was mentioned below
Can the immo data transfered to the donor ecu?
Attach the original readings.
Hi, I need good solution egr off and dtc off P1404 (vcds 17812). I can´t do it basic settings egr. New egr/ wiring ok
Skoda Fabia 1.4 BBY 036906034CB MM IAW 4MV
I'm using the Xentry (09/2024) with openport J2534. When I try to connect to my S204 it gets through all of the pre-diagnostic steps - check vin, reading modules etc. And after that stays on this screen:
and then nothing happens. The program is not freezed or stuck, just stays on this screen forever.
But when I connect to my father's W205 there's no problem. It gets passed that screen and I'm able to diagnose modules for errors, to check and do different tests - for example I did EGR tests.
Hello friends, could you help me with Fiat Idea software, I need the same original software. I have already checked the Dimsport database and they do not have it available.
If anyone has the original unmodified software I am willing to pay for it.
The software and hardware number is:
![[Image: IMG-20241027-200011.jpg]](https://i.ibb.co/wg6LLDd/IMG-20241027-200011.jpg)
