2008 E60 4.4 after ecu swap, dsc light is on and on diagnostic it says steering angle sensor problem, in live data it shwos -1440° i tried adjusting it but unsuccesful using autel im608. I was told it needs coding. Any idea how its coded ?
Hello Could someone check the files if there's any modification?
We've problem with black smoke, customer change maf, injectors, intake smoke test, all parameters look ok, but black smoke when accelerate won't dissapear
Car is Volvo S60, 2011 year, 2.0 D3 , Ecu EDC17C22
Hello,
I have problem with Opel Corsa D Easytronic. After clutch replace, there is error P1735 and flashing F on board. I can't make the calibration, because it want to start the car, but i can't start because of F fault on cluster.
I saw that is possible to repair EEPROM 24c16 and after that to make adaptation.
Can someone check and repair my Eeprom file?
Hello everybody, someone knows please how to check compatibility of a bdc ? Or how to get original référence from vin ? Any help Will be very appreciated.
hy friends, can someone have a working solution for immo off of this sid 803A fiat scudo 2007.
Car far away from me, please only working solution, thanks to all
attacched 95320 eeprom
Hello,after timing belt change 2019 vw 2.0tdi fault :
P0087-Rail fuel pressure too low ,when accelerating
It is posible, that high pressure fuel pump have timing mark ?
Every thing is changed from sensors to injectors now
Hi guys
I am loooking for a wiring diagram for Toyota Land Cruiser 1HD-FTE model KR-HDJ101K-RNAGZ.
I need the instrument cluster wiring diagram because it keeps blowing the cluster as soon as you turn key on
Hello,
I have problem with toyota C-HR engine MAXH10 M20A-FXS. Car start for 5-10 seconds and engine stall.
Every time have one code: P3193 Fuel Run Out.
I'm checked fuel pump and pressure from tank: LOW pressure 3 bar, and HIGH about 6 bar.
Try replace high pressure fuel pump from another car.
Replace fuel in tank.
Engine have 2 fuel rails. High an Low
Low pressure sensor about 390 kpa when engine run
High pressure from 5000 kpa to 18000 kpa and engine goes out. When the pressure is around 5000-6000kpa the engine works normally, but after a few second pressure starts to increase and engine stalls.
I think problem is to high fuel pressure, but why pressure rissing?
Maybe someone had experience witch such a problem?
hi all i need if someone can help to delete egr for my ecu DCM3.2AP Rexton D20DT It's already DPF Off but after one year engine is in limp mode and egr error appear in diagnostic
Could someone check the files if there's any modification? 
