Hello ,

On OM651 i blanked the egr it should be off with the tune. But when you drive the car it's shaking. When i took of the blank it looked like this. What might be the problem?

Attached Files

Thumbnail(s)
   

Hello, i virgin bsi peugeot 208 eeprom Valeo N03, and i need to recode and set pin.

The probleme is whene i start key learning key, and i set the last code pin, the diag say its not good pin (virgin), what i need to do that bsi take a new pin like ecu and key.

I use autel im608 and i cant do it

Thank you

Hello guys , after installing microcat epc 2019 , when im going to run it gives the error " it needs an autorized dongle " 
can anyone help ? 
best regards

Attached Files

Thumbnail(s)
   

Hi, i lost the vgs data for a transmission, the chassis number of the car is 4JGBF71E37A133409, new VGS part number is 0034460310.
Can someone please help me with software number and coding?
Thank you

hi please dpf off additive off
citroen  1,6 hdi
sid 807 evo
continental
thanks

Hi, does anybody have an EEPROM Dump from a Ki164 AMG instrument cluster. I need both 200mph and 320 kmh eeprom dumps if possible. 

Thanks in advance


EDIT: Since everybody was very (un)helpful I have obtained a Ki164 EEPROM another way. 

PW after thank and rep+.

Attached Files

Ki164 AMG EEPROM.txt

2

73 bytes

Download

Hi folks!

Quick question, when I first got my R171 with 722.9 it would often downshift 3 or 4 gears when I nailed it. 
Over the years the firmware was updated and it lost this native functionality. 
I've since replaced the conductor plate with a new OE unit and it has the latest firmware but I'm wondering if it's possible to get back the original downshift design?

I am looking for an engine diagram for a Peugeot 307 2.0 tdi, 2003
ecu edc15c2

thanks

Rychu

Hello friends 
I need help checksum correction 
Hyundai Meg17.9.2
Pcmflash don't do checksum correction and give me verification error
In attachment orginal file and immo off file

Attached Files

Meg17.9.2.zip

3

1.23 MB

Download

Hi, I want to read a MCU Fujitsu MB91F376G. Its from a Mercedes W164 (KI164) instrument cluster. Does anybody have experience with which tool I can read, and ideally write that chip? 

Thanks for any input on the matter

Hello MHH Members,

can someone help me please to correct the checksum on a VAG Bosch ME3.8.3 ECU?

Please find attached ori file and mod file.

Thanks.

re, Andi

Attached Files

06A906018R_0261204673_ORI.rar

5

76.05 KB

Download

Mod file_ Checksum correction needed.rar

6

76.56 KB

Download

 Ford IDS + FJDS + FDRS Software License – 1 Year Subscription

Get the  original Ford IDS, and FDRS license for professional-level diagnostics and programming. This is an authentic license, not a patch or cracked version, ensuring full access to all features and updates. 

Price is 300usd.

Hi, I have a 2017 Golf R which i believe has a bad ecu. I have the exact p/n replacement used ecu. What is the best way to go about getting it coded. Is it possible with vcp? i am a noob to ecu programming so plz explain it to me as if i am a golden retriever. Thanks

Hello, today I came across with this 44 volt battery from a 2024 C300 (W206) Mercedes.

First time this model. I can not find any information/nor recognize eeprom or mcu for crash removal.


Anyone with info or pictures for how to fix this? Thanks

Attached Files

Thumbnail(s)
               

Hello so i drive a bmw e46 330d 184hp 2000" and i got a stage 1 and its good and everything but stage 2 is better u know what i mean but my question is is it really that bad if i drive everything stock with a stage 2 and if so what do i really need to change is a bigger intercooler enough i dont have a dpf.

Thank You!!

TRUCK OLS  DATABASE AVAILABLE FOR 1000 EUROS

PAYPAL PAYMENT ACCEPTED

PLEASE CHECK ATTACHED XLS SHEET

PM ME IF INTERESTED

MORE DATABASES AVAILABLE  AT DISCOUNTED PRICES

[font="MHH Font", Calibri, sans-serif]Ford fdrs,ids,FJDS original license,PATS login (remote coding programming)[/font]
[font="MHH Font", Calibri, sans-serif]Login and download please help [/font]

Dear all,
       Due to technical reasons, many people are currently unable to go online.Provide online services temporarily (not long-term), note that the service is not a sales account or login.The price is 50 US dollars at a time, and I have the right to choose customers.For do this, you need diagbox interface. If J2534 interface, i not sure if work for diagbox.

Best Regards.

Service Temporarily closed, the technical fault has been repaired.

Can anyone help me reset this angle sensor file on my 2020 corolla? 

Eeprom : 24c02

Thanks in advance.

Attached Files

sensor steering-toyota-corolla-2021-24cs0-24-02.zip

3

381 bytes

Download

Hi friends, I have a problem with a dashboard, I changed the KM by OBD2 and the screen stayed blue.

Kia Sportage GT line (2018)

tablero 94033-D9170

con un micro Yazaki (NEC 70F3526 + 25C160)

Hello everyone!

Apologies in advance as I’m new here, and I’m still figuring out the proper procedures. I’m just learning how to use these tools.
I have a C4 and Xentry version 03/22.

I’m having an issue with my 2014 Mercedes GLK 350 CDI.

I tried using Vediamo software to display the remaining fuel amount on the trip computer, but I only managed to create problems.. I’m not even sure what I did, just followed Youtube instructions  The next day, the fuel gauge started showing empty, and the fuel warning light is also on. The tank is full.

Using Xentry, I checked the instrument cluster control unit for measurement values, and it shows the fuel amount as zero.
Can I calibrate the fuel level using Xentry, or what would you recommend I do?
Thank you

I cant write origo int flash 03L906018G__9240

WRITING ECU
Writing in progress... UNCORRECT FILE 014400 - OTP SECTOR NOT WRITEBLE
Writing complete. UNCORRECT FILE 014400 - OTP SECTOR NOT WRITEBLE


in bench mode same with boot mode

Donor ECU
03L906018HK

Infineon Tricore TC1767
CPU-ID=0000900100001820
Internal Flash ID = 0053C001
Internal Flash 2048Kb  Protected
MCU ID: 4180820511408D26740800101114FF00
OTP Protect: 0x10000 -- 0x13FFF
OTP Protect: 0x14000 -- 0x17FFF
EEprom 64Kb  Protected

After flashing M5.2.1 ( bimmertuningtools)with OBD, the car doesn't start and displays "failsafe" (engine in security mode). Has anyone encountered this issue before? How can I resolve it? The connection with OBD was lost.

Hall anyone able to remotely install,

I have installed to win 10 and device is not recognised but software all opens ok . Think it’s driver issue

I have tried with VM but still struggling

Hello. How are u? Please i need replace ABS 8.0 on Audi A4 B7 2.0 tdi 140. 
Ori is         0265234336      050527/5/1251  8E0 614 517 AK
and new is 0265234336      060601/5/2997  8E0 614 517 BF
Do u that it could there be a problem of compatibility because of these small differences?
Or else which number could matched with ori one?
I mean numbers must be absolutely the same?
G201 sensor is inside ABS or outside?

Best regards.

btw: 100000 excuses. I have posted twice. Please a moderator could remove the second and keep the first one?

Hello. How are u? Please i need replace ABS 8.0 on Audi A4 B7 2.0 tdi 140. 
Ori is         050527/5/1251  8E0 614 517 AK
and new is 060601/5/2997  8E0 614 517 BF
Do u that it could there be a problem of compatibility because of these small differences?
Or else which number could matched with ori one?
I mean numbers must be absolutely the same?

Best regards.

I have read the ECU via KessV2 Clone OBD.
Can anyone check the File.
I think its a uncomlete Read.

Attached Files

Audi A6.txt

6

82 bytes

Download

Hello, i need to turn egr off in Fiat Croma 1.9 JTD.
HW: 0281012963
SW: 1037500042


read Fgtech V54

Attached Files

0281012963 read V54.rar

5

33.57 KB

Download

Hello guys,
Does anyone know what the coding for the m271 sim4 ecu.

When I flashed my ecu a long time ago the coding was lost and I reconstructed from memory, but I have doubts about it.

Does anyone know the correct factory coding for the e200 211.041?

Or does anyone know the explanantion and what the settings influence?
1. Ehb ( probably something with sbc from prefacelift)
2. Ftk/aad ? What does it do? Should it be active?
3.Hinterachsuebersetzung 1-4? what does 1 -4 influence?
4.Getriebeschaltpunktsteuerung?

 Thank you


Abgasvariante
Baureihe
Diagnose-Gateway
ECO Lenkhilfpumpe
EHB Funktionalität
FTK/AAD
Freigabe Programmierung CO-Korrektur
Freigabe Programmierung LL-Drehzahlanhebung
Freigabe Programmierung MKV-Korrektur
Freigabe Programmierung ROZ-Korrektur
Generatorschnittstelle
Getriebe
Getriebeschaltpunktsteuerung
Hinterachsuebersetzung 1-4
KAT
KAT-Heizen
Karosserie
Kickdown-Raste
Klimaanlage
Lüfter
Lüfternachlauf
Modelljahr
Motorisierung
Offset Radumfang VA
Recht/Linkslenker
Schichtbetrieb
Schlechtspritland
Sekundaerlufteinblasung
Tempomat
Tempomatbedienhebel
Traktionskontrolle
Uebersetzungsverhaeltnis Hinterachse fuer Tempomat
Verdichtung
maximalgeschwindigkeit
Ölsensor/-schalter

Does anyone have flash for this ecu its fujitsu ten from toyota IQ

Calibration  89663-74060
Part num.    89661-74060