I have had chip tuning done on this car by a local software company.
However, the car does not accelerate up to 2700 rpm at the moment, it starts to accelerate after 2700 rpm.
EGR is physically disabled in the car, I do not know what they did in terms of software.
Hybrid turbo was made.
There is a downpipe and the catalyst is disabled.
There is no intercooler right now, but I am thinking of installing it in the future.
I am attaching the original file and the file made by the local software developer. I would be happy if you send me a file in the form of Stage 2.
Hello everyone. I performed an EGR + DPF programming on a Mercedes Sprinter 416 Van, year 2019 and after a few days the Van stopped working. It lost the key pairing and does not start the vehicle. I have already tried to recover by returning to the original backup and even so the vehicle no longer works. I would like to know if anyone can perform some remote engineering programming. I have Trasdata and also available MB Xentry.
I search some dump of vd56.1 automatic (Peugeot Citroën) read by autotuner or kess or similar...
If someone çan provide me full dump i ll enjoy them for sure intro a manual to automatic conversion into dump, as a gift i will share my solution to all who deserve me to help me with those dumps..
Dont tell me to Ask le mans i know hé own a good collection but seems dont want to help me since the immo off that didnt work..
hi, I have a problem misfiring cyl 1 when the car warms up, tried a new ignition coil, new spark plugs, tried changing the place of the injectors, did a leak down test, changed the place of the camshaft solenoid valve. I am looking for an electrical schematic for this engine ecu, I want to check signals to the injectors and ignition coil in the ecu connector
Hi im looking for some damos or definition file for this bin, i would like to do some tuning maybe some hard limiter pops and bangs launch control if possible just for fun
Hello, can anyone help me with connecting to esp module in my car? I'm trying to code cruise control, already connected to ic and cgw and coded them, but when i try to connect to esp_1 i get following error: "03029: ECU responded with a refuse message to the init message". I'm using vediamo 4.02.02 with openport. Am I using wrong cbf file?
Hey all
Today I installed used 5G transmission. After test drive, there is a problem. It shifts only 2nd and 3rd gear. And when i turn off and again turn on car it starts with first gear,but when it goes to 2nd or 3rd it stops betwen these two. Is there anyone that had this problem? Dtc is first gear is unplaussible or gear slippery. When i goes in actual values when switch is in P or N it reads all rpms but when I put it in R od D everything goes to 0,except engine rpm.
