Hi guys.
Who can help me? I need information about what resistor is soldered in the place (photo). I lost it during re-soldering, and I did not check the resistance before the operation. ECU 03C906056T MED9.5.10. Mant thanks in advance.
My early 2019 W177 does not support opening the sunroof using voice commands. When I ask "Open the sliding roof" it just responds with "I can't help with it right now". It does however open the blind. I've upgraded the TSSR177 software and checked the coding but I cannot seem to find something obvious that is disabled. Also, the HU6 module has been updated numerous times over the air, so it doesn't seem like this is an old firmware issue. Does anyone know how you can enable this like on 2020+ cars?
i have problem with range rover L320; it's akl ... I have use xt27 i have not write because VVDi2 tell if you use superchip doesnt write.
now i have tested but doesnt start.
what is issue? who have add key in cem with vvdi2 (position 1 and 2 used)? what is process with xt27? xt27 work? i add in position 3 it s empty and write?
Hello everyone! Help me figure out the error P0600. A car with a damaged PCM arrived to me, which was not subject to restoration! But the eeprom was not intact, I bought an engine control unit from a dismantling site by the number one to one, cloned the eeprom and installed it on the car. The car starts without problems! But the engine control unit has the error code P0600. There are no errors in other units! Mopar's description of the solution to this error is updating the software of the unit! The unit has been updated! But the error remains! I smoked another unit, also made a clone, but the error remained! If anyone knows a solution to this problem, help!
MPC212 HW: 0009051900
The car has option 513 from factory
I want to activate traffic sign recognition in Finland, but there was no variant codings in MPC212.
Flashed 0009025904_001.cff to camera, and codings appeared including land codings.
However, now MPC212 has trouble code A29B56 - The coding data do not fit the vehicle, and lane assist is inoperative as well as speed limit assist.
I will attach current variant codings of SAMF, ZGW and MPC212. Is there something wrong, or do I have to update software of other modules also?
I am writing here to ask for help with activating Agility Mode on my 2008 Mercedes-Benz W211 220 CDI. Usually I do find the information I need, but now I cannot, and I've hit a wall haha.
I want to activate Agility mode on my W211 2008 year, it is 220 CDI with 170hp.
And everything is working, but when I look into my diagversion number it gives me " 0353 ", and everything I've looked or saw was some sort of 0401 etc..
VGSNAG2 doesn't have anything with 0353, 7G SCN also.
Some of my questions are:
Is it even possible to activate (in a simple way), if my diagversion 0353 is nowhere to be seen?
Ford fiesta 1.5 tdci (2017 new model) 6mx65 gerarbox
I have a problem with my own car.
The clutch and hydraulic slave cylinder is replaced.
After replacement we put several syringe with brake oil in the line, but on the top in the reservoir came bubbles.
This clutch slave have no bleeding nipple, so we make the hose loose and air comes out, we did the pedal method many hours but i think it take false air.
Hello everyone,
After writing modified file with KESS2, comes P0601 now. Engine starts and dies.
I have tried to write back Original file. Same issue.
Could someone take a look at both files and to fix Checksum.
