Hello . Need full bdm for this ecu please .
Someone damage ecu by writing with SM2 clone
i will post damage ecu read on bdm , id of ecu done by the guy witch damage ecu and picture of ecu lable
I have VW Multivan 2016 yearwith gearbox DQ500. Need help to change mileage value. Ori value is 572100 (checked with vcds), need new value 344200. In attached dump read with flex bench mode. Regards
Hi to everyone, I have a car that has wrong ecu ,the car need a different sw, I found a complete backup but cannot clone because of otp,
soI need to write new file to old ecu and then make it immo off.
If i write new flash to old ecu, I will get p160A error
Is my idea of changing software realistic? can be done without errors?
can someone help me with that?
thank you in advance!
[font="MHH Font", Calibri, sans-serif]Hi there.[/font] [font="MHH Font", Calibri, sans-serif]I got a Med9.1 - 2.0TFSI K04 and I want to raise the boost above 2.5bar. Does anyone offer a solution or maybe the 5120 hack?[/font] [font="MHH Font", Calibri, sans-serif]Thanks in advance![/font]
Hello mhh, we have a strange issue with this car- car cranks and fuel pump operates, ECU has been cloned by request of another mechanic (ori and donor files attached), can you please help us with maps check from MPC and maybe advise on the folowing - those DTC's are permanently shown in Diagbox and cannot be deleted. Also, ECU status in data stream is locked, but matching OK. DTC's are:
U0404 – Gear information fault
P0014 – Exhaust camshaft dephasing fault
P2231 – Fault upstream oxygen sensor signal
P2195 – Information of the mixture between the upstream sensor and the downstream sensor
P0171 – Mixture regulation fault
P0053 – Upstream oxygen sensor resistance fault
P0135 – Upstream oxygen sensor heating control fault
P0343 – Inlet cylinder reference sensor signal fault
Could you also maybe check if ori flash/maps in MPC is okay? Any advise would be great, many thanks in advance! Both ORI and DONOR files attached.
Do vehicle manufacturers, in particular, VW / Audi, provide definition files for OBDII data logging tools to companies like bosch, vag-com, obd11, autel, etc? Surely these companies aren't reverse engineering the info on their own for every single ECU part number. If that's the case, does anyone know where to get them, or where I could learn more on the subject?
I have VW Caddy with bifuel CNG ECU(HW: 0261S04651). CNG was replaced with LPG installation with separated LPG control unit.
Need remove DTC's:
013192 (P3388-004)
013177 (P3379-004)
013212 (P339C-004)
013221 (P33A5-004)
013218 (P33A2-004)
013204 (P3394-004)
013201 (P3391-004)
013215 (P339F-004)
013207 (P3397-001)
013187 (P3383-001)
013190 (P3386-001)
