I have a BMW 325i 2.5l 2006 and was wondering if its worth remapping the car?
Does anyone have experience mapping these cars and what are the likely gains.
I have mapped my own cars in the past but they were all turbo cars.
Also can any one recommend a good mapper, especially with this engine?
My car is completely standard.
When configuring new module with SDD, It does not allow it and gives error for "The application is not available on this RFA, The RFA must be replaced before retrying this application"
RFA has only 1 dtc - below 2x keys programmed (which is normal from previous experience with virgin RFA)
RFA has comms on diagnostic
The same files have been used on the same FK72 RFA on a Land Rover and worked without issue so files cannot be a problem, SDD also shows no VIN in RFA and all 8 key slots unused
Any advice on what the problem is or how to get the RFA to configure
Could someone help me with proper FAP/DPF off along with eolys?
Please no cracked davinci solutions, they cause white smoke after some time, would prefer only working solutions.
Is it possible changing rod bearings just dropping the transmission? I mean do all the work under the car without engine out? n57 2013 530d f11 No X drive, Thank you.
good evening I have a problem with a jaguar xe 2.0cdti180cv August 2018 the car broke the engine because of the fap. replaced the engine did the necessary resets but the car as soon as you start it stays with the wind, idle and smells of regeneration.
has anyone ever had similar problems?
I also did a sw update in jaguar but nothing to do always the same thing I tried more solutions but nothing. has it ever happened to anyone and do you have a solution that can work. thanks
ecu medc17.9
Hi, is anyone can help me with Esitronic 2.0 ? I had license on my dcu 130 at Esitronic to 2019. One of guys at my workshop change date on deskopt and nów esitronic dosen't work. There is failure about license expire. Is there any chance to fix it? I used esitronic with KTS 540.
I am hoping someone can assist with finding these Original Files,
I use Alientech Kess V3 to read/write, The VR ORI files are not available for the Hilux's I read,