Hi Everyone, I have 2018 Ford Expedition with bad PCM, I replaced the PCM and programed it using FDRS but now I need to do parameter reset, any one can help because I dont have NASTF account.
Are the sidemirror turnsignals also available as channels in HLI or somehwere else in W213 and X167? I cannot find them as separate channel in HLI in DTS
I have in garage a Opel Antara 2007 2.0 TDI EDC16C39, after someone ha used the booster to let start the car with battery ko, the central locking is not answering, no windows, and the dash is turing on after 10 seconds su have moved the key on. After if you open and close the ignition always on immediatly, but there isn't the check engine symbol.
Ecu read in bench, all ok.
I had another, all the same numbers, nothing has changed.
The body is answering and without errors, all the errors are about ecu not found in the most part of the otehe units
[color=var(--YLNNHc)]Every workshop owner comes across intractable problems for which he cannot find a solution, and he even searches to buy these solutions but cannot. Yes, problems that involve money cannot be found on YouTube. If you suffer from any problem with modern German cars from the Volkswagen group. All solutions are available to me[/color]
Hello, if anyone can assist me with a solution for Zafira C Delco E98 ECU for AdBlue but without Message on Dash about AdBlue Level.
Tested DaVinci Original and ECU 0 Errors but still Dash have Error.
Tried to Reset AdBlue level and data but besides 2500km till engine wont start, message about AdBlue level is still on the dash.
Hello. I have problem with EDC15VM+ (012M). I changed coding with VCDS to select another codeblock, but I select number 3 in coding and I got error and coudnt change back stock coding to existing codeblock!
I rewrited the maps with boot mode, but no success!
Could You help me, please? How I can reset the ECU stock coding?
Hello. I have a rather unusual problem. I have a 2020 C5 Aircross. No messages are displayed on the dashboard. When I want to turn on the ACC Cruise Control, a yellow message appears on the dashboard that maintaining the distance between vehicles is unavailable, along with the message, the key light comes on. After scanning the vehicle, the diagbox does not have any errors related to incorrect ACC operation. Has anyone encountered a similar problem and can suggest what to look for?
[font="MHH Font", Calibri, sans-serif]Hello friends, Can someone Immo off this please![/font] i have two file from ktag BDM Read, I want to try change new ecu and immo off for that because im not have pin from old ECU.
Hello guys, I have problem with Audi A8 3.0 V6 with EDC16CP34. I did dpf off on bench, after that when I start the vehicle EEPROM changes. After 100-150km, car is dead (when I write EEPROm back, car starts). I flash back Ori FLASH adn it did nothing, so DPF solution is OK.
What can cause that EEPROM changes and after time I cannot start the car?
Hello i want to retrofit CLC cluster into my facelift W203.What i need to do for this job ?
I have star and vediamo(tactrix clone)
Also eeprom programmer
[/font]
