I recently bought broken kts 540.
After opening it I found out that some chips were burnt. When attempting to read am29f800bb flash I got an error (reading new empty spare flash was fine).
Is it possible to just upload flash from another kts 540 and have perfectly working one?
Is there any device specific data that I would have to change? Serial number?
If no, could anyone provide good flash?
Hi dear members,
I'm dealing with this car, in another garage changed TCU for some reason,
Now i have fault code: the gear is implausible or slipping.
Vin: WDF63970513282057
Diff: 3.727
EGS52- 032 545 38 32
Hey guys! I just did a fresh install of ISTA-P with Loader 6.6 and every time I open it the loader screen just gets stuck going back and forth in a loop. Any suggestions or insight on how to fix it? Any help would be much appreciated!
Hello,
I need help to correct mileage in BCM to Instrument cluster of Fiat Ducato 2008 year, eeprom 95160.
Mileage in BCM have to change to 141 500 km.
So i have this situation the car cluster with the original EWM sometimes doesnt detect shifts, so it cant start, we decide to change the EWM and to replace the EEPROM 93c56 and FLASH 1D69J from old ESM to the new(second hand) ESM, the car start once and then stop detecting at all, now the problem worsen, next thing i did is to bring back the orginal EEPROM and FLASH to the old ESM and read the original EEPROM and write it to the new(second hand) and try again, with original EWM the car detected once D and R and when you go to P nothing, and stop detecting again, with the new(second hand) absolutely nothing. Can someone help what i can do next i have a PROG only and can read the the EEPROM and FLASH and also i have EIS data.
could someone help me with this. Orange 5 and carprog doesnt find correct mileage from this dump so I cant chage it. It has 107km but I need 10000km. It has been read as 16bit
I bought a AHU engine from a Seat Alhambra (AHU 1.9 Tdi) with an ECU 028 916 021 ES. I would like to install this engine in a T3 transporter.
I disassembled the ECU and soldered out the B58253 eeprom. I tdied to read the eeprom with a Ch341a programmer. But I cannot read the B58253. As I konow this eeprom compatible with 24C02. I also tested the programmer with an another 24Cxxx IC it woked, so i think the programmer is ok. I also tried many softwares. Is it possible I bricked the eeprom? I also tried to solder it on a test board so I think this error is not caused by a wrong connection.
Do anyone help me to give me a 24C02 bin file for 028 906 021 ES or help me with some idea to read the oroginal eeprom.
