Hi
I have a 2016 Jaguar XF, the problem is that the doors suddenly stopped closing.
Only the fuel filler flap works with the remote control, the alarm goes off and the door remains open
HI,
SRS 8W0 959 655 F
I only have the B2000 error and the invalid data set.
After deleting the B2000 data set I will make odis online.
I only need to delete the B2000
Hi,
i am trying to read full flash from simos 11.1 with sak tc1738 inside,
i tried to connect boot pins similar to ems2204 because it has same cpu, but with no luck,
does someone have connection diagram for this ecu boot mode ?
Hello!
I wan't to ask for your help, I tried to disable the p1121 error with my programs without succes.
Could someone help me please?
Thank you very much!
Hello gentlemen I need your help I need to clear the memory on Virgin for Citroen Xsara this is the first two years of Siemens BSI on the 95 160 memory Can someone help
As far as I understand OBD odometer correction not possible. Solder or BDM / clip only. Correct?
Please help me with these questions:
1. Is the odometer data recorded in KMs and converted to miles by the processor Like old Audi? Or is it recorded in miles?
2. Addresses where odometer data is in eeprom dump please?
3. Any software to Generate odometer dump bytes? I have TachoCalc somewhere which is good for old cars but I'm not sure if this works for 1st gen jazz/fit.
I recently bought broken kts 540.
After opening it I found out that some chips were burnt. When attempting to read am29f800bb flash I got an error (reading new empty spare flash was fine).
Is it possible to just upload flash from another kts 540 and have perfectly working one?
Is there any device specific data that I would have to change? Serial number?
If no, could anyone provide good flash?
Hi dear members,
I'm dealing with this car, in another garage changed TCU for some reason,
Now i have fault code: the gear is implausible or slipping.
Vin: WDF63970513282057
Diff: 3.727
EGS52- 032 545 38 32