Hi, I want a good sharp cut in stationary mode. It's automatic. I've tried several solutions, and they're not very good without sound. I don't want to cut with SVLR, but with NM at 4400 rpm. Thanks.
Hi everyone,
I need a pre-Dieselgate FRF file to flash with ODIS.
I currently have version 9979, and a friend who works at Volkswagen updated my ECU via Odis-e, but now I have version 9984. What would be the correct pre-Dieselgate version?
Thanks everyone.
Hi everyone! I have a problem with Adblue off in Renault Traffic 2021.
Trying 2 solutions , one of them from davinci , the problem is check emmision message on dash.
Can this car have a DCU? If yes where located?
Read from ECU in attachmant , thanks for attention and help!
Hi, after updating BCM my keys were deleted. The car responds to the key by flashing but will not lock or unlock. Cannot start. I tried to add the lost key via pathfinder, but the action ends with the message RFA must be replaced before completing. Is there any way around this?
Hello everyone,
I have an Alfa Gilia Quadrifoglio, from 2022. Car jumped over the curb while sliding to the right, and stopped on a fence. No major damage, mostly cosmetics.
Changed (aside from trim pieces):
- FR headlight
- Front carbon splitter, calibrated
- Radar was disconnected, but reconnected and calibrated
- Both right wheels, and both right wheel bearings
- Both right doors
Now an error appears in the ECU (not ABS unit) whenever the car gets up to temperature: C0047-00. MES gives no further info on the code. OBDLink app identifies it as "Brake Booster Pressure Sensor" electrical fault, but I think it might not be a correct description. I am not an expert, but isn't everything in Giulia integrated into the Continental MK C1 unit? No separate brake booster sensor?
I'm looking for any information regarding this C0047 error in Alfa Giulias.
Hello friends, i got a golf 5 that got a donor dsg from an passat. I have tried to flash dq250 ori from an golf 5 with 2.0 tdi engine but there is implasuible signal error on vcds. Does any one had a read bin file of dsg with an 1.9 tdi engine?
Here is the free version of sysma, When I disassembled the program, I found references to more advanced versions, hopefully a crafty software engineer can figure out how to activate these other levels.
Hi guys. I´m helping out friend with individualy built street legal car. It uses Subaru EJ205 (2005 2.0 Subaru Forester 162Kw for US Market Engine). It´s stock engine apart from upgraded turbocharger to IHI VF34.
ECU map offloaded using WIN Flash. Find at attached.
I´d like to have done following:
180KmH speed limit removed
Maximum engine rpm increased to 7200
Boost increased to reach ca 280HP
Happy to pay for your service via paypal, revolut or wise.
We tried local tuners, but the files were not working ok.
it stays constant on, if turn right indicator it stays on if left stays on, hazard same thing, i can hear relay clicking, only way to turn them off if battery disconnect. ordered bcm, probblem not there, unplugged hazard switch, indicator stalk, even radio problem still there. anyone had similar? Thanks
Hi. I have VW Crafter 2.5tdi with ecu EDC16CP34 0281014982 074997032F SW:1037503924 and i need full backup from this ecu because i have problem no starting engine after a few kilometers after mod in other service. Thank you for your help.
