Dear All
I have MB GLE53 AMG 2023 if drive for long distance with sport mode with high repm got these codes : P1551E1 & P0CD700 Coolant Temp Sensor of 48V Hybrid Battery short circuit to ground as shown in attached picture and showing( 48V battery see operators Manuals) , Mainely am working with trucks not cars but this is my own car and the workshop here couldn't find the reason, We changed 48V hybrid battery , we changed Coolant pump , and same problem , they still thinking problem in coolant pump , I told him the fault saying shortcircuit to ground I told him problem in coolant sensor in hybrid battery , he said not this dtc appear if battery got hot .
Any one has experience with his ? u know maybe where is this Hybrind coolant sensor ? .
Appreciate your support .
Hey can anyone help i have a urus and have maked a stage1 and pop and bangs but after my solution when i put car in M mode it go off can any one look ?
Hello, I have Audi A8 with Symphony radio. I wanted to flash EU software to it, but can't seem to find any info on how to proceed. I tried flashing it with RG3Mid_ECE_0310.sgo using VCP. It took a while, finished correctly, but software on radio did not change. I think that this sgo file is for audi concert, not audi symphony. Can anyone share some info about that ? Can it be flashed with correct sgo file ? Or do I need to change eeprom first ? I need to change the radio frequency and add polish language to this system. I know for sure it's doable, as there are people that managed to do this. Can anyone help in that matter ?
I can’t read D-Flash as I get partition error with Hexprog and XP400. Can anyone provide a virgin file?
Also, P-Flash is reading slightly different every time. The files aren’t exactly identical between any read I’ve done - including the XP400 with read verification set on.
hello, I need an original file for a BMW 320d E90.
If someone would be so kind as to provide it...
The ECU data is as follows:
0281012754
1037376967.
EDC16C35
ECU DDE EDC16+ M58BW016xB - CHANGE DRIVER
w204 after changing and coding the ecu with vediamo, I have an error on the turbine actuator. probably on the donor car there was a vacuum actuator and on this one it is electric. I changed all the parameters with vediamo except one that doesn't work. is the one for engine power. How could I solve the problem? The car does have power. turbo is not working.
Hi, could someone please help me immo off this ecu. Water damage to old ecu and no communication in bench or boot mode. I have a donor ecu read taken with flex bench.