Hello, i have a cluster from vw bora with 24C02 chip inside, tried odometer correction via OBD but it doesnt work, can anyone correct it if i read and send file?
thank you
HELLO I POSTED FILE TO DEFAPE EGR OFF AND REMOVE SWIRL AND DTC OFF OPEL ZAFIRA B 1.9 CDTI 150CV EDC16C9. MY PC DROPPED AND THE HARD DRIVE IS DAMAGED. IF SOMEONE CAN REBOOT ME HERE ARE DTC P03400 AND P2279-1 THANKS
hello i have w211 ezs and problem is key is reading only in one side, i check the eeprom to make new key i have hash error on all keys can somone repair the eeprom.
Hello everyone, I need some help.
I am looking for a complete flash of a DCM6.2V with SW 04L906056AG 9970.
Unfortunately any Virutal Read, FRF or similar files will not help
Thanks!
Wanted person to code lamps remotely in Touran 5T after replacing from halogen to top LED. and removing the component protection. ODIS 5054, VCP, VCDS available
Good morning, does anyone have a dump of an airbag control unit with a gateway dump from the same car? I have an A5 whose original airbag control unit has been scrapped. I need the control unit EEPROM and the gateway EEPROM to adapt the component protection. My control unit reference is 8K0959655J. Thanks everyone.
Now W1K205 year about 2021 has problem water flood so now my key it’s not woking We found a problem with the keyless go control unit getting water in. Part A 222 900 00 16 rear in trunk lid near rear sam module it’s can Replace ? If part number is correct or need to programing about key ? Thank you
Hello, maybe someone can help whit crash data for this FIAt 500 2017
MOPAR 52115352
bosch 0285015027
eeprom 95640
After clear crash with CPT I got this faults:
B01112F Driver remote acceleration sensor (Satellite)- Signal erratic
B01122F Passenger reomte acceleration sensor (Satellite) - Signal erratic
My son-in-law bought a 2012 Nissan Titan pickup. The rear cab sliding window rolled down, but then wouldn't go back up. We replaced the motor and it still wouldn't work. When using the window switch that is above the rear view mirror I can hear a click in the dash area by the drivers door.
I was able to get the window to roll up by putting power and ground directly to the new motor. I'm thinking a relay may be the issue.
Anyone have access to a diagram that could help me locate the relay?
Also, problem #2, no horn or cruise control. We were told the clockspring was bad when he bought the truck. We replaced the clock spring and still no horn or cruise control.
I'm trying to Update Navigation Software of Comand NTG4 to V16.
but since weeks with different set's of DVD's it always ended at 97% and Rest starts with asking for DVD 1 to restart
So i tried to Update the Comand via Engineering Menü "Sw Update"
So the device asked for Update CD "21.11.01"!,
This is what i couldn't find anywhere..
As well as MB-Dealer could not answer this..
Does anyone know what "Update CD 21.11.01" is and where i can find it?...
