The following information will be passed into the Factory Passwords System:
[*]Display Code: 232
[*]Feature Code: 1%146%3%0 J1
[*]Product ID:
[*]Component Serial Number: BP84126U003034E AT
[*]Service Tool Serial Number: ET-111111-10 XY
[*]ECM Serial Number: 16297074VN V9
[*]Additional Data 1: %%EB7 BF
[*]Additional Data 2:
[*]Reason: 3
[*]Software Part Number: 5610971-00 QM If the above information is correct, please click on the link below. https://fpsdma.perkins.com/fpsdma/ Created: Thursday, 8:46, 2025/3/13
hi all
can someone generate coding?
vin: WVWZZZ6RZCY186152
vw POLO 6R hatchback
ESP8.2i front H05 0002
Front 256mm disc - rear 200mm drums
with TPMS
1.2 tdi engine code: CFWA
Hi! Can someone help me with Renault Trafic Edc17C84 dpf&egr off , adblue is already Off .
I tried one solution but regeneration still active , much smoke, had someone solution?
HW: 237106626R
SW: 237109983R
Thanks!
Hello. I have dead ecu in my car. I bought used ecu and also original file from internet. Can you virginize this file? Is it possible to take immo off without emulator? Thanks in advance.
Hello everyone, I'm coming to you because I read a Dodge Ram 3.6 309 Gpec2a ECU and I would like to know if the file is 100% original. Thanks to those who can help me.
P208B04 The output for the AdBlue® delivery pump has a malfunction. There is an internal fault.
Changed delivery pump, done delivery pump learned values reset using Xentry and still getting this fault code.
With both delivery pumps getting this fault code and delivery pump stops working. After erasing fault codes I can do delivery pump test and most of the time it fails, pressure starting to build up then after 2 seconds getting error and pump stops working. Then deleting fault code, trying to do test again and some times it fails straight away , sometimes it works . For example sometimes I can do pump test 5 times or even more in a row and all the time all good, pressure building up as it should be no fault code. But after 10 minutes or etc again same fault code.
Even tried to replace AdBlue control unit that is behind rear SAM module. Still getting same error.
Hello, does anyone have and can share the ori file?
Can anyone explain how the duration selection works and which code block in the driver’s wish is used with a warm engine.
Hi, I have problem with 2012 evoque,
Power tailgate is opening but won’t close, there are no errors in whole car I tried adaptation form sdd, and it goes well until point when tailgate should close itself, I get only “general error” message,
Any ideas what should I check ? Can someone tell me which sensors can stop tailgate from closing ?
Hi, need help to repair the pcb on automatic gear lever for Mercedes W639. It does not recognize gears on display and sometimes stay blocked. Errors: P240C, P1856 and P2261. Thanks.