Hi Mates, I open another post for ecu syncronisation citroen jumper sid 208. Ecu dumps readed by magpro2 x17, bsi eeprom with programmer. Need sync between ecu and bsi. Im ready to pay for this!
Hi
I have only ecus without car. I have ecu with broken soft and from working good car. I need transfer only immo line from ori to second by. I saw in smok that can make virgin but I dont have this license.
Can you help me.
I post two eproms.
Hi all,
W212 HU NTG4.5 has missing HW & SW part numbers in Engineering mode, as attached. All functions running normal, except AUX
Anyone has idea what is the issue? Will update the firmware will fix this issue? and what is telematics version to update HU?
Please advise.
Hi i have this file with stuck kilometres i try to put ffff (like aygo...) but does not running the total kilometrs.
has got any body good file?
157000km has got...
Hello how are u? Please which soft in order to do DPF Off on jeep wrangler year 2018 EDC17CP27 ?
Or else is it possible to do it with a good guide inside winols? If yes please could i have it?
Best regards.
hi friends. I need to fully disable the EGR in a 2000 Ford Transit, 2.0tddi, visteon control unit.
A solution is needed to disconnect the connectors from the EGR control vacuum valve and from the EGR valve position sensor.
I found the EGR maps and disabled dtc p0403, p0404, p0409. There are no more fault codes in the pcm. but the glow plug light is flashing on the instrument panel and the car is in power limit mode. If i connect the plug to the EGR position sensor, the spiral goes out and the limitation mode disappears. but that doesn't suit me. the connector must be disconnected.
I'm sure there is a solution. Perhaps it involves emulating the signal from the EGR position sensor at the software level in the computer. but maybe I'm wrong. but there is definitely a solution. can anyone help? in the archive is the original file and my EGR-off.