Hi. I need help fixing Burbles in my [BMW-MSV80-9RX MG5-E90-330, I did it, but the car is giving Burbles for the first [5 minutes] and then stops giving Burbles after that to run normally as if I did nothing.
Can anyone advise me on what to do?
With the latests VAG security updates when using Odis for Immo Repair process, I am really struggling on getting a reliable suportter for GRP online accesses or the old Geko Online (sometimes is working, sometimes servers are down).
Need some indications from you guys someone we can trust on doing this services remotely.
If you can point someone, I appreciate. You can also send me PM.
Congratulations, friends! Does anyone have the technical ability to remotely connect Renault Daster to the server via Clip? Reprogramming of the blocks: electric power steering, BCM and ECU is required. The car was started from 24v, the blocks have already been replaced. But the car is blocked.
Hello, could someone take a look at an eeprom file and maybe try to do a IMMO off?
The file is from an Audi A4 B7 2.0 TDi EDC16U31, part no. 03G 906 016 GN
I have tried to do it via ECU Vonix 3.2 and car won't start and it throws a code regarding the EEPROM in the ECU and the Glow-Plug light flashes. The DTC is 18048
I have attached the virgin file below.
Hi to all, i make immo off in Hyundai Accent ECU M798 39101-26AD1 and need recalculate check sum. I work with IO Terminal.
Original and immo off file atached.
Thanks in advanced.
Hello, I tried to clear crash data on a 2021 Renault Master using Renolink, but I think something went wrong. Before clearing, I had the codes B12B5, B0001, and B1029. After the procedure, only B1036 remains, and no other DTCs are showing, even though the airbags are still deployed.
It's T4FL_ACU_x62_v1.5
Did I make a mistake by not selecting "Ecu to replace"?
What should I do now?
Bartery voltage was to low. Now everything is ok. Solved
[font="MHH Font", Calibri, sans-serif]Hy! Anyone can help me with an immo off?[/font] [font="MHH Font", Calibri, sans-serif]Thank you![/font] [font="MHH Font", Calibri, sans-serif] SIMOS 7.1A 06A906033 EP
93c86 eprom
will give thanks plus reps to you[/font]
I have a problem with my W203 Sport Coupe, which brakes by itself. I checked the live data from the yaw rate sensor, and the readings are unstable even when the car is stationary. I replaced the sensor, but the problem persists.
The car heated up to 30 degrees does not want to start. It start when I disconnect the temperature sensor. I did a soft update, raised the starting dose in address 3D306 and 3D3B6 but no change. Something else besides these maps needs to be changed?