Hello, I have read out the Passat B8 MQB D70F3532 instrument cluster with multiprog.
But I can't just read out the data flash. Only the complete chip.
Can someone decode the IMMO data for me pliz?
Hello, I had a serious problem with my engine harness, I ordered a harness from Europe but the problem is that the plug for the oil pressure sensor has only one pin while my car takes the one that has 03 pins.
The problem is that while driving, starting from 60 km/h as soon as the oil warning light is displayed above 2500 rpm, the computer cuts the accelerator and it is complicated for me to rebuild the vehicle to the original.
My question is, can someone make a switch off of the oil monitoring to prevent the computer from cutting the acceleration?
I can pay of course.
Thank you!
My car is 2013 Opel Antara 2.2Cdti Delphi DCM3.7AP.
hello , can someone make proper soliution to turn off dpf and egr correctly?
after programing this ecu need to reset adaptations off particle filter?
its been ideal if someone have proper files
one eco systems off
and second eco systems off and eco chiptuning , i try both files and select wich is fine for my car, im afraid for stage 1 , becouse n47 engines are very problematic, or what is the limit without damaging the internal components? share your experience with this engines tiuning....
64 reg citroen c4 picasso. instrument.9808860580. changed it for secondhand unit now mileage too high. mileage is showing 127545 miles. need it correcting to 85550 miles please if someone could help. dump is attached 95160 eeprom from cluster. i no bsi has to be changed as well, will upload later. please state it is miles and not kilometers. thanks
I wanted your advice on a common issue with these damn MK60EC1 abs units on vag cars ......
The infamous 01130 ...
I do have 5 x plus faulty abs units at my store right now and i wanted to ask ,,, do you know any serious company (besides actronics and ecutesting) that can repair these ones ?
Hello so i have a Stage 1 on m E46 330d 184hp and since i put that on with Kess 2 i always have the DTC P1640 eeprom fault and configuration does someone know whats up with that i uploaded my ori file and stage 1
The lambda/o2 sensor bank 1 touched the exhaust and melted the harness. I replaced the harness and sensor but am still getting no signal on lambda bank 1 (before CAT).
I tried to clone the ECU to a spare I sourced using a Ktag (clone). Unfortunately, the write failed. (I managed to get a good full read from both the donor and the new ECU in ksuite 2.25). I'm trying to revive the ECU so I can try and flash again.
I have tried KTAG and kess clones cant read it. I have tried NFS in emergency mode but it can't detect the HW number.
Is there any way to force a flash? Is there any way to recover this ECU?
Hi everyone, I'm a beginner at chip tuning. I want to tune my audi a6 c7 3.0 tdi CDUD edc17cp44. For this I need a Mappack, who can share such a mappack?
Hello, I reinstalled my Diag PC over the holidays. I installed the Xentry 12-2024 and Vediamo, 5.01, DTS Monaco 8.16 and 9 and released it with Fullfix 7.25. So far it works, but with DTS 8.16 I have a problem with the projects that worked fine before. In the "Short Test" window, no ECUs are displayed, although they are "let through". Under the tabs e.g. variant coding they are visible. For all projects ! That was different before, I also can't get the ENET cable installed despite the correct IP.
