Hello. Maybe someone know where exactly Kessy module located on 2013 Continental GTC convertible? And what i need to remove for get access to Kessy. A have only pictures from ETKA where show, module located beck of the rear seat. Unfortunately, I can't find it. Unter front driver seat find empty box. Thanks.
I hope this is ok, and i bet its also a stupid question but i got 2 errors after installment, i have followed the guide 3 times without success. I dont know what i do wrong or missing? I hope this could be fixed without re-installing Windows. And also i have put secure boot in disabled mode.
So
This happens when trying to start the sdp3
First error
"USB Key
Envelope unknown error e0031"
Second error
"A problem occurred when the program was used. This may be because of incorrect installation of the program."
Does someone know what to do? If so i really appreciat an easy guide =)
I With it being Christmas time thought I could give something to hopefully help someone else. CTZ to BIN converter in the mega link below. It will only be active until December 31st! If anyone else has something to share they think could help someone go ahead and leave it below!
I need a Stage 2 flexfuel for Audi S3 8V with simos12.1 ECU.
Parts installed HPF vismotorsport kit, LPF walbro 520, MPI 980cc injectors, milltek downpipe, turbo cts intake.
Iveco daily ECU Has 129715 need 79715. Hours need around 1500. Thanks in advance and happy holidays
DUMP tool y smok dont work i find 12666KM and 3207 hours
Hi, Im trying to adapt a diesel Ki164 to a gasoline W164. Is there any way to edit in coding or eeprom for the RPM needle to show correct gasoline rpm? Ofc I can change the background to gasoline, but I am unsure of the coding or bytes in eeprom which should be changed.
I have EEPROM dumps from gasoline and diesel KI164 but they are all very different.
Does anybody have experience with this? Could somebody point me in the right direction?
Thanks in advance for any information related to the matter
I have an Smart EV 453 with P0852, I see it's a DC/DC converter problem.
Can anybody say me if it's possible repair? If I can do o where can I send to repair it?
I have a problem with my 2011 Skoda Octavia 2.0 TDI. Last week, the glow plug warning light turned on and off repeatedly. Since then, I’ve noticed slight black smoke. Today, the glow plug warning light stayed on along with the check engine light. The car is emitting smoke, the engine loses power, doesn’t accelerate, and ends up stalling after a few seconds. When I restart, the engine runs for a few seconds with smoke and then shuts off again. What could be the cause? Here’s the list of fault codes I found: P029900, P106500, P008700, P010400, P256400. Could you explain the solution? There is the attached pictures of faults code.
So, about a year (20,000 miles) ago, the DPF was removed from the car and cleaned / flushed after the car complained that the filter was full.
It's complaining again.
When a forced regen is attempted via TechStream, the car doesn't seem to do anything. I believe the car was at a suitable temperature, with enough fuel in the tank.
I looking solution VW tiguan 2016 year virtual cockpit 10485826 - Internal Control Module Memory Check Sum Error B2000 41 [009] - General checksum failure fault code. No error mesage in instrument cluster and speeker working.
Is there anyone who can help me get to hardcut since it was not enough to change the tourque limiter map
To get it to work
It's a Mercedes w203 270cdi edc15c6
It's not original folders
Hello
, I have a project to modify the Audi TT Mk1 APX 225hp engine.
:Turbo k04 stage2 (up to 320hp)
Donwpipe decata
Injectors 630cc
Intercooler
Does anyone have a stage 3 for this configuration?
I read the file with galetto but the car was already in stage 2 reprogramming and the file seems to protect.
Does anyone have a solution to help me? Tanks
Hi i need ADBLUE off for my Van. I hit adblue pump on stone and now it counted down km to 0. Can not fix wires and pump itself so need ADBLUE off .
I can start car with CLIP but it has to be done every second time.
Hello,
Looking to buy database for Trucks as in Topic. Files must be tested and safe in case of road inspection. Generall EU trucks needed.
Pls contact me if You loike to sell it!
REgards,
Simon
![[Image: Untitled.jpg]](https://i.ibb.co/wJQPWwF/Untitled.jpg)
