I buyed a used Rear sam with the same Part number as mine because mine has problems and i want to coding it but how to do?
can anyone explain me step by step how to coding it with VEDIAMO? I just wanted to take the source code from the old one using Vediamo and paste it into the new one, does that work?
i can also pay for someone who are specializes in this area
hello im looking solution for BCM virgin in LandRover Discovery 3/4 2.7d v6 2009my
BCM read vvdi like 9S12DG256 flash 256kb and eeprom 4kb
and read one eeprom like vvdi instruction 1KB
some one can help me ?
As in the subject
Renault captur 1.5 dci automatic
Car after crossings, no cruise control.
Speed limiter works.
Errors DF1016, DF1012 on the engine
I need to add cruise control with renolink
i had problem with freelander 2 - there was immobilizer signal problem to ECU (Crank : Yes, but no motor start)
DTC 1259 - 85 immobilizer signal to ECU
ECU is EDC16CP39 - 2.2 diesel manual transmission
some people said to me that there no chance to immo off on this ECU
whats why i go and buy NEW EDC16CP39 - maybe with automatic transmission
Hy I have a hino 700 denso ecu misfiring with temp sensor connected the water Nd diesel one if I let the sensor hanging no misfire, some one can make the map for this ?
The car is running, but for some reason the VIN number is damaged in the ECU. I tried to restore it using Can Clip - unsuccessfully, Launch - unsuccessfully. I read EEPROM 95320, manually entered the VIN number and write in EEPROM, it didn't help. Then I realized that there is a VIN checksum, I don't know how to recalculate it. Help me if anyone can, thank you very much.
Just fitted a used radio to a 2016 Nissan Juke, the old Radio had 360 camera, however the new one even with the same part number only has reverse camera - assuming its a software issue how do I correct this?
I need original file for. ECU-то е Bosch EDC16C35 2.12. Full Info :
VIN: WBANC32050CP66054
Number of ECU: 7799855
HW: 0281012754
SW: 1037376967
SW upg.7799948
Hi everyone, who can help me to eliminate this dtc code P0234 or increase the turbo pressure limiters in this file, the car does not go into protection when the code comes out, it only turns on the warning light. I do not have the original file
I did immo off on an iaw59f. Already done a thousand other times with IAW DECODER. This time however the car does not start unless you put the antenna. In practice the program writes immo off but only does virgin Has anything like this ever happened to you?