Please, drive 10 minutes in a superb and make several mistakes. The key is not found, the blinker blinks stupidly (sound). The electrician is going crazy. He deleted everything and I'm sending right after the first log error. Thanks so much for all the advice.
Hi, I’ve searched the forum and there seemed to be a few older posts for MHD flasher N54 but all of the links/posts are dead! Does anyone have the file still?
Cheers
Hello everybody, just received a Mini Cooper Hardtop 2019 gasoline 1.5l 3 cylinders manual gearbox keyless.
Car is likely dead, when i put battery, radio, a/c turn on immediatly but start stop button not work, no ignition on cluster. No communication with nothing on diag
I think BDC is culprit as old one was flooded, they tried to change and car became likely dead.
I have one wrong key, programmed (4 buttons not 3 buttons and error on dash). Can I delete all keys and program again old original and new correct key only? Need reset keys somehow before procedure or not?
I have a dq200 pressure drops below 42 bar while ignition is on and the pump does not switch on again. It does switch back on when I start vehicle. P1895 functional restriction due to pressure drop. No other codes. New dealer valve body. The pressure actually drops very quickly.
I am coding with DTS Monaco 9.
The adaptive cruise control on the W177 displays a warning if the steering is not properly operated.
When driving in a straight line, these warnings are stressful, so I am looking for the coding setting to either disable the warning or extend the time before the warning appears.
Do you know where this setting is? Also, if you know how, could you please tell me how to display the AMG options on the meter screen?
Hello. I am looking for an installation scheme for motorcycles as in the title. I have an idea to make a retrofit tft display for bmw f 800gs and I need to check what the differences are. And whether it's feasible.
I have an Astra G clasic with engine code Z14XEP. It starts hard when cold, you have to start it several times before it starts. The problem is not the fuel pressure, because I measured the pressure, I installed the gauge in the evening and in the morning there was still 3 bars of pressure. Injectors are good, temperature sensor values are good. It starts well up to about 12 degrees Celsius, when it is inside the workshop it starts well. If I force it to start on gas, it starts on gas, but not on gasoline. Any ideas?
![[Image: 810dbd4c47fa156248fa12fbdfcc34fa.jpg]](https://uploads.tapatalk-cdn.com/20241012/810dbd4c47fa156248fa12fbdfcc34fa.jpg)
