Got opel Vivaro 1.6 with EDC17C84 ecu, somebody tried to delete adblue and egr. Solution was not good, now i need original to do it properly. Will pay for original no problem File in bellow
Hello
Can some one help me.
I´m new at this, i have ecm titanium and winols download from the forum.
I can open the file that i download from my car with kess2 but none of the programs give-me the maps of the unit.
i would like to now if some one can help.
it´s just for self learning.
I will put the file of my car, if some one could do lamba 2 off the car have a decat exhaust
Tks
Hi everyone I need advice and help if someone can provide me with that
I'm trying to clone crd3.10 using foxflash and multiprog
Flash and eeprom recovered using boot
Full flash 4mb
Eeprom 32k
Think is after writing flash ECU lost communication only working on boot
If I'm writing original files to ECU same issue ECU bot responding in bench
Is any procedure for that ECU any one had same issue and can help please
I have 2 Binary files from a Ford Falcon EL 1996-1998 ( mid series cluster), of which the cluster has an 8 pin eprom of X24c44 on board.
I have got a dump from each cluster. I'm trying to determine the Odometer value and locations within the dump.
I assume its 16 byte length.
I was converting the following bytes from hex to decimal, but i would dare to say the checksum needs changing.
can anyone share the sequence to perform the change or modify the attached files?
Overall, i would like to change the odometer values for each file to have an odometer value of 85,000 KM
Thanks in advance,
Mazda 6 2014 2.5 petrol controller DENSO P5AH-18881-B P5AH-188K2-B - PELJ-188K1 car also for sale gives error P0421 catalytic converter efficiency, is anyone able to eliminate the errors?
Renault Master 2018 I need to replace the engine control unit. The original ecu is soaked. No immo data. I made the controller used virgin. When programming, I have to enter a 13-digit immo code. Can someone help me with immo code?
Hi guys.I have removed old DSG tranmission S-tronic DL501 gen 1,by the way car is Q5 2.0tdi 170hp 2009,and installed used transmission DL501 gen2 from 2.0 tfsi.Can someone help me to transfer immo data from old mehatronic Temic unit gen1 to new unit gen2,TCU DL501.Thanks in advance!
One of my main gripes with my MY23 GLE V167 (Belgian market) is that I can't choose between distronic and non-distronic cruise, it's distronic or nothing.
I've looked around in the variant coding, but haven't been able to find anything.
Now, with doing some more research, I found that in some markets the steering wheel buttons are different, and contain a button to toggle distronic!
My buttons, A09990508042A17:
The other buttons, A09990511042A17:
Now, my question is: Would these be a straight swap, or would any coding need to be done to enable this?
I'd hate to lose the limiter functionality, but I'd love to be able to disable distronic even more.
Hi every one know about geko problems now and i cant make CP of this module. Than need cloning it. I cant finde any pinouts.. I tryed change motorola on pcb and havent communication with module.. Soldering 100% ok. There is any component more to need change?? THX!!!!
File in bellow 
