Hi
I replaced the dash in Astra J 2011
I replaced it because I had a small display
I changed the VIN number and PIN code using ABRITES
but I cannot change the dash configuration. The display shows errors about low coolant level and low windshield washer fluid level, check the parking sensor system.
How and with what to turn it off
Hello friends, im in need of help with
mercedes W212 e220 cdi
2011 OM651 engine 2.1 125KW
Automatic transmission
got fault: P042815 - Temp. sensor 1 "catalytic converter" (cylinder bank 1)
I need DPF and O2 OFF
Thank you
is there anyone able to reset soot mass on edc17cp14 direct on file?
I do the resets and soot is set as 0 but after i tried to make a regen and odis says the soot is 60g and is not possible to make the service regen.
There is no dtc but DPF dash light is always on as soon as ignition is on.
DPF was replaced by a new.
hi friends...
need some help
I have 3 files from BMW E82
P-FLASH
D-FLASH(empty)
EEE-FLASH
this FRM3R is blocked, cant be programmed in car, so i read files by BDM wiith X-PROG.
need some help to restore files to original state, is it possible?
thanks
I searched for a solution and decided to start a new thread
I ran into a problem while updating NTG 4.5.
I did an update for HW 2049011803 from > SW 1729028103 to > SW 2129029210
1. After update process finished I got an error message in Vediamo "After flashing only the ecu's boot or base variant could be detected." I was able to communicate with NTG only in boot mode.
2. Found a post that first it needs to be update to SW 1669024607 prior to SW 2129029210. Did that and was getting an error in Vediamo "Flash process failed<...>. General controller error."
3. Unfortunately NTG went into sleep and now I can't connect to it or start it. Black screen no connection via Vediamo Xentry.
I'm out of options at the moment.
Is there a way to bring this unit back at least to boot mode and re-flash it?
I hope you can share some guidelines or tips how can this be resolved.
Maybe someone can help, I'm reading the flash using an external tl886 programmer, I play the file but the car no longer fires, counting the total, etc, unfortunately the vehicle does not fire, fans are spinning, etc, I attach the flash dump
Maybe someone from the forum will advise...
I have an MBUX HU6 in my car and I need to install it in another .
In order to activate it, an "activation KEY" is required, which I will have to bring to the new car.
Is it possible to read it from HU6 while it's still in the old car, and it works??
I tried with DTS monaco with the System activation code Read option, but the option doesn't give anything.
Firewalls are disconnected, hu is active.
Maybe there are other ways?? Can someone advise??
Thanks for the information.
